User manual

6
Before using your dishwasher for the
first time:
1. Ensure that the electrical and water connections
comply with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and
then fill with salt
5. Fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener
designed to remove minerals and salts from the
water supply, which would have a detrimental or
adverse effect on the operation of the appliance.
The higher the content of these salts, the harder
your water is.
Water hardness is measured in equivalent scales,
German degrees, French degrees and PPM (parts
per Million).
The softener should be adjusted according to the
hardness of the water in your area.Your local Water
Authority can advise you on the hardness of the
water in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener
should be adjusted.
To select a different level be sure that
the dishwasher is off and then proceed
as follows:
1. Press 70° 80’ and 65°
programme push buttons simultaneously.
2. Always keeping pressed the programme push
buttons 70° 80’ and 65° switch on the
dishwasher by pressing the ON-OFF push
button.
The ON-OFF indicator light comes on.
At the same time, also the indicator light of the
70° 80’ comes on and remains fixed for about 5
seconds, after this it starts flashing indicating the
current level of the water softener.
Before use
Level
Use of
salt
French
degrees
(°TH)
PPM
(Parts per
Million)
German
degrees
(°dH)
1
2
3
4
5
NO
YES
YES
YES
YES
< 4
4 - 18
19 - 29
30 - 40
41 - 50
< 8
8 - 30
31 - 50
51 - 70
71 - 90
< 80
81 - 300
301 - 500
501 - 700
701 - 900
Water hardness
SO412