User manual

This appliance has been fitted with
safety features which will prevent
the water used in the appliance from
returning back into the drinking wa-
ter system. This appliance complies
with the applicable plumbing regu-
lations.
Water inlet hose with safety valve
After connecting the double-walled wa-
ter inlet hose, the safety valve is next to
the tap. Therefore the water inlet hose is
only under pressure while the water is
running. If the water inlet hose starts to
leak during this operation, the safety
valve cuts off the running water.
Please take care when installing the wa-
ter inlet hose:
• The electrical cable for the safety valve
is in the double-walled water inlet
hose. Do not immerse the water inlet
hose or the safety valve in water.
• If water inlet hose or the safety valve
is damaged, remove the mains plug
immediately.
• A water inlet hose with safety valve
must only be replaced by a specialist
or by the Service Force Centre.
• Place the water inlet hose in such a
way that it is never higher than the
bottom edge of the safety valve.
Warning! Dangerous voltage.
Water outlet hose connection
The end of the drain hose can be con-
nected in the following ways:
1. To the sink outlet spigot, securing it
to the underside of the work surface.
This will prevent waste water from
the sink running into the machine.
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm.
The waste connection must be at a
height of between 30 cm (minimum) and
100 cm (maximum) from the bottom of
the dishwasher.
The drain hose can face either to the
right or left of the dishwasher.
Ensure the hose is not bent or squashed
as this could prevent or slow down the
discharge of water.
The sink plug must not be in place when
the machine is draining as this could
cause the water to syphon back into the
machine.
If you use a drain hose extension it must
be no longer than 2 metres and its inter-
nal diameter must be no smaller than the
diameter of the hose provided.
installation electrolux 33