User manual

4. If you use detergent tablets, put the de-
tergent tablet in the detergent dispenser
(A) .
5. Close the lid of the detergent dispenser.
Press the lid until it locks into position.
Different brands of detergent dissolve
in different times. Some detergent tab-
lets do not have the best cleaning re-
sults during short washing programs.
Use long washing programs when you
use detergent tablets to fully remove
the detergent.
MULTITAB FUNCTION
The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are suitable for
the local water hardness. Refer to the in-
structions from the manufacturer.
The multitab function can be set with any
program.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function automatically stops
the rinse aid and water softener operation.
The rinse aid indicator light and salt indica-
tor light are deactivated.
The program duration can increase if you
use the multitab function.
Activate or deactivate the multitab
function before the start of a washing
program.
You cannot activate or deactivate the
multitab function when the program
operates. Cancel the washing program,
then set the program again.
To activate the multitab function:
• Press the multitab button. The multitab
indicator light comes on.
To deactivate the multitab function:
• Press the multitab button. The multitab
indicator light goes off.
To activate/deactivate the rinse aid
dispenser:
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C.
– The indicator lights for function but-
tons A, B, and C start to flash.
4. Press function button B.
– The indicator lights for function but-
tons A and C go off.
– The indicator light for function button
B continues to flash.
5. Press function button B again.
– The Ready indicator light comes on.
6. Switch off the appliance to save the op-
eration.
To deactivate the rinse aid dispenser follow
the above steps until the Ready indicator
light goes off.
To use normal detergent again:
1. Deactivate the multitab function.
2. Fill the salt container and rinse aid
dispenser.
3. Adjust the water hardness setting
to the highest level.
4. Do a washing program without
dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the rinse aid dosage.
12 electrolux