User manual

SELECT AND START A WASHING PROGRAM
Set the washing program with the door
ajar. The washing program only starts
after you close the door. Until then it is
possible to modify the settings.
1. Press the on/off button.
2. Make sure that the appliance is in set-
ting mode.
3. Press one of the program buttons. Refer
to the 'Washing programs' chart for
program details.
– The indicator light of the selected pro-
gram stays on. All other program indi-
cator lights go off.
– The digital display shows 3 horizontal
bars.
– The indicator lights for the set wash-
ing program, start to flash.
4. Close the door.
– The washing program starts automat-
ically.
– Only the indicator light for the operat-
ing program phase is on.
– The digital display shows 1 horizontal
bar and stays on for all the program
duration.
When the washing program operates,
you cannot change the program. Can-
cel the washing program. Refer to
'Cancelling a washing program'.
Select and start a washing program
with delay start
1. Press the on/off button.
2. Set a washing program.
3. Press the delay start button until the
digital display shows the necessary de-
lay start of the washing program.
4. Close the door.
– The countdown starts. The display
shows remaining time to the start of
the washing program.
– When the countdown is completed,
the washing program starts automati-
cally.
If you open the door during the count-
down, this will interrupt the countdown.
When you close the door again, the
countdown continues from the point of
interruption.
Cancelling delay start
1. Press and hold at the same time func-
tion buttons B and C buttons until all the
program lights come on and the digital
display shows 3 horizontal bars.
– When you cancel delay start, you also
cancel the washing program.
2. Set a new washing program.
Warning! Only interrupt or cancel a
washing program if necessary. Open
the door carefully. Hot steam and
water can escape.
Interrupting a washing program
1. Open the appliance door. The washing
program stops.
2. Close the appliance door. The washing
program continues from the point of in-
terruption.
Cancelling a washing program
1. Press and hold at the same time func-
tion buttons B and C buttons until all the
program lights come on and the digital
display shows 3 horizontal bars.
2. Release the two buttons, the washing
program has been cancelled.
At this point, you can follow these steps:
1. Switch off the appliance.
2. set a new washing program.
Fill the detergent dispenser with detergent
before you set a new washing program.
End of the washing program
The washing program is complete when:
• The digital display goes off.
• The Ready indicator light comes on.
1. Switch off the appliance.
2. Open the door.
– For better drying results, keep the
door ajar for some minutes before
you remove the dishes.
Let the dishes cool down before you re-
move them from the appliance. Hot dishes
are easily damaged.
Removing the load
• First remove items from the lower basket,
then from the upper basket.
electrolux 13