User manual

INSTALLATION
Fitting under a counter
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Put the appliance adjacent to a water tap
and a water drain.
The plinth of a freestanding appliance is not
adjustable.
Do not remove the appliance's worktop if
you want to use it as a freestanding unit.
It is not necessary to remove the worktop
when installing under a standard kitchen
bench top.
Only remove the appliance worktop to in-
stall it under a close fitting sink unit or kitch-
en worktop (820mm).
Make sure that the dimensions of the re-
cess agree with the given dimensions.
Follow steps listed below to remove
the appliance worktop
1. Remove the rear screws (1).
2. Pull the worktop behind the appliance
(2).
3. Lift the worktop and move it from the
front slots (3).
4. Level the appliance using the adjustable
feet.
5. Install the appliance under the kitchen
worktop. Ensure that water hoses are
not kinked or squashed.
The appliance must be easily accessible to
the technician if a repair is necessary.
Adjusting the level of the appliance
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or
tighten the adjustable feet until the appli-
ance is level.
WATER CONNECTION
Water inlet hose
Connect the appliance to a cold water sup-
ply.
Connect the inlet hose to a water tap with
an external BSP thread spout of 3/4”.
Inlet water supply
• Cold water pressure: 800 kPa max - 50
kPa min.
• Water flow rate 10 L / minute min.
18 electrolux