User manual

First try to find a solution to the problem (re-
fer to the chart). If not, contact the service
centre.
Malfunction Fault
code
Possible cause Possible solution
The appliance
does not fill with
water.
The display
shows
The water tap is blocked or is
furred with limescale.
Clean the water tap.
The water pressure is too low. Contact your local water author-
ity.
The water tap is closed. Open the water tap.
The filter in the water inlet hose
is blocked.
Clean the filter.
The connection of the water in-
let hose is not correct.
Make sure that the connection
is correct.
The water inlet hose is dam-
aged.
Make sure that the water inlet
hose has no damages.
The appliance
does not drain
the water.
The display
shows
There is a blockage in the sink
spigot.
Clean the sink spigot.
The connection of the water
drain hose is not correct.
Make sure that the connection
is correct.
The water drain hose is dam-
aged.
Make sure that the water drain
hose has no damages.
The anti-flood
device operates.
The display
shows
Close the water tap and contact
the service centre.
The programme
does not start.
The appliance door is open. Close the door correctly.
The mains plug is not connec-
ted in.
Put in the mains plug.
Blow out fuse in the household
fuse box.
Replace the fuse.
The delay start is set. If you want to cancel the delay
start, refer to 'Select and start a
washing programme'.
After the check, switch on the appliance.
The programme continues from the point of
interruption.
If the malfunction shows again, contact the
service centre.
If the display shows other fault codes, con-
tact the service centre.
The necessary data for the service centre is
on the rating plate.
We recommend that you write the data
here:
Model (MOD.) ....................
Product number (PNC) ....................
Serial number (S.N.) ....................
electrolux 13