User manual

Arrangement cutlery basket
Installation
Warning! Any electrical and/or
plumbing work required to install this
appliance must be carried out by a
qualified electrician and/or plumber or
competent person.
Remove all packaging before you position
the appliance.
Position the appliance next to a water tap
and a drain.
This appliance must be fitted under a kitchen
counter or work surface.
The dimensions of the recess must be the
same as shown in the figure.
No further openings for the venting of the ap-
pliance are required, but only to let the water
inlet hose, the drain hose and the mains ca-
ble pass through.
The appliance is fitted with adjustable feet so
the height of the recess can vary between
820 mm and 880 mm from the floor.
Leave a space of 2 mm between the top of
the appliance and the underside of the kitch-
en counter.
The appliance must be unplugged during all
operations that involve accessibility to inter-
nal components .
Make sure that the water inlet hose, the drain
hose and the supply cable are not kinked or
squashed when inserting the machine,
Adjusting the height of the appliance
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw
in the middle of the front kick plate to the
left or to the right. Good levelling is es-
sential for correct closure and sealing of
the door.
20 electrolux