User manual

When the appliance is correctly levelled,
the door will not catch on the levelling
spacers on either side of the cabinet. If
the door does not close properly, loosen
or tighten the adjustable feet until the
machine is perfectly level.
Adjusting the height of the plinth
It is important for the dishwasher to be ab-
solutely horizontal so that the door seals
properly. The adjustable feet are to be turned
to the left or right until the dishwasher is hor-
izontal. If there is a space at the bottom of the
machine, this can be covered by lowering the
plinth.
Fit the adhesive protection foil onto the front
part of the worktop, along the entire width.
Adhesive steam protection foil
Fit the steam protection onto the front part of
the worktop along the entire width.
600 mm
Fix to the adjacent units
Warning! THE APPLIANCE MUST BE
SECURED UNDER THE WORKTOP OR
TO THE ADJACENT UNITS USING THE
SUPPLIED BRACKETS.
FAILURE TO DO THIS CAN CAUSE IN-
JURY OR DAMAGE.
1. Fit the supplied angular brackets in the
slots on the top of the appliance.
2. Secure the appliance in position (up-
wards or sideways) by using the supplied
screws. Make sure the screws are tight-
ened.
Caution! Never drill holes through the
sides of the appliance. This will cause
damage to the hydraulic components.
electrolux 21