User Manual

26 electrolux.com.au
Error code Possible cause and solution Control
F1 Overfill
• Power off your machine and close the tap.
• Contact the customers services centre.
F2 Not draining
• Water discharge hose is clogged.
• Water drainage hose kinked, check installation.
• The filters of your machine might be clogged.
• Power off–on your machine and activate the
program cancellation command.
• If the error continues, contact the Customer
Care Centre.
F3 Inlet valve faulty
• Close the tap.
• Contact the Customer Care Centre.
F5 Inadequate water supply
• Make sure the water tap is fully open and that
there is mains water available.
• Water inlet hose kinked, check installation.
• Close the water tap, disconnect the hose from
the tap and clean the filter at the connection.
• Restart your machine, contact the service if the
error resumes.
F6 Faulty heater sensor
• Contact the Customer Care Centre.
F7 Over temperature • Contact the Customer Care Centre.
F8 Heating error • Contact the Customer Care Centre.
F9 Diverter valve faulty • Contact the Customer Care Centre.
FE Power supply problem • Contact the Customer Care Centre.
Error codes, cause and solution
TROUBLESHOOTING (CONTINUED)