User manual

Before using your dishwasher for the
first time:
1. Ensure that the electrical and water connections comply
with the installation instructions
2. Remove all packaging from inside the appliance
3. Set the water softener
4. Pour 1 litre of water inside the salt container and then fill
with salt
5. Fill the rinse aid dispenser.
Setting the water softener
The dishwasher is equipped with a water softener designed to
remove minerals and salts from the water supply, which would
have a detrimental or adverse effect on the operation of the
appliance.
The higher the content of these salts, the harder your water is.
Water hardness is measured in equivalent scales, German
degrees, French degrees and PPM (parts per Million).
The softener should be adjusted according to the hardness of
the water in your area. Your local Water Authority can advise
you on the hardness of the water in your area.
The dishwasher is factory set at level 3.
If this level is not suitable for your area the softener should be
adjusted.
If your water is level 1 it is already soft and therefore there
is no need to use salt.
With the setting of the water softener at level 1 the salt
indicator light on the control panel will always remain off.
Use salt from level 2 upwards.
From level 2 upwards, if salt refilling is necessary, the salt
indicator light will illuminate only in setting mode and at
the end of the washing programme.
During the run of the programme it will remain off.
Before use
Level
Use of
salt
French
degrees
(°TH)
PPM
(Parts per
Million)
German
degrees
(°dH)
1
2
3
4
5
NO
YES
YES
YES
YES
< 4
4 - 18
19 - 29
30 - 40
41 - 50
< 8
8 - 30
31 - 50
51 - 70
71 - 90
< 80
81 - 300
301 - 500
501 - 700
701 - 900
Water hardness
4
1. On/Off indicator light
2. On/Off push button
3. Door handle
4. Programme selection push buttons
5. Delay start push button
This option allows the start of the programme to be
delayed by 3, 6 or 9 hours.
6. Indicator lights
Phase indicator lights
Washing phase
illuminates when the washing phase is running
Drying phase
illuminates when the drying phase is running
End of programme
illuminates when the washing programme has
ended
Salt and rinse aid indicator lights
Salt refilling indicator light
illuminates when the salt has run out and the salt
container requires refilling.
Rinse aid refilling indicator light
illuminates when the rinse aid has run out and the
rinse aid container requires refilling.
The control panel