User manual

6
Rinse aid
Rinse aid is automatically added during the last rinse, ensuring
thorough rinsing, and spot and streak free drying. The
dispenser, which is positioned inside the door, holds about 110
ml of rinse aid, which is sufficient for 16 - 40 dishwashing
programmes, depending upon the dosage setting.
Filling with rinse aid
1. Open the container by turning the lid (A) anticlockwise.
2. Add the rinse aid until the container is completely full.
The indicator (B) will be completely dark.
3. Top up the rinse aid when the rinse aid indicator light on the
control panel illuminates.
If rinse aid refilling is necessary, the rinse aid indicator
light will illuminate only in setting mode and at the end of
the washing programme.
During the run of the programme it will remain off.
Ensure that the lid is closed after every refill.
Do not put liquid detergent in the rinse aid compartment. Clean
up any rinse aid spilt during filling with an absorbent cloth to
avoid excess foaming during the next wash.
It is possible to deactivate the rinse aid indicator light (see
the following instructions). By default the rinse aid indicator
light is active.
To deactivate the rinse aid indicator
light be sure that the dishwasher is off
and then proceed as follows:
1. Press "Intensive 70°" and "Normal 65°" programme push
buttons simultaneously.
2. While keeping the programme push buttons "Intensive 70°"
and "Normal 65°" pressed switch on the dishwasher by
pressing the On/Off push button.
The On/Off indicator light comes on.
At the same time, the indicator lights of the "Intensive 70°"
and "Normal 65°" push buttons start flashing.
3. Press the "Normal 65°" push button, the correspondent
indicator light keeps flashing while the indicator light of the
"Intensive 70°" push button turns off.
At the same time the indicator light "end of programme"
starts to flash.
4. Press the "Normal 65°" push button again, the "end of
programme" indicator light turns off, this means that the
rinse aid indicator light has been deactivated.
5. To memorise the operation, switch off the dishwasher by
pressing the On/Off push button.
To reactivate the rinse aid indicator light follow the same
process until the "end of programme" indicator light starts to
flash.
Adjusting the dose
According to the finish and drying results obtained, adjust the
dose of rinse aid by means of the 6 position selector (C)
(position 1 minimum dosage, position 6 maximum dosage).
Increase the dose if there are drops of water or lime spots on
the dishes after washing.
Reduce it if there are sticky whitish streaks on the dishes.
BR01
BR03
SO544
SO542
BR02