User manual

We recommend every 3 months you run the
wash programme for heavy soiled dishes us-
ing detergent but without dishes.
Prolonged periods of non-operation
If you are not using the machine for a pro-
longed period of time you are advised to:
1. Unplug the appliance and then turn off
the water.
2. Leave the door ajar to prevent the forma-
tion of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location
where the temperature is below 0°C. If this is
unavoidable, empty the machine, close the
appliance door, disconnect the water inlet
pipe and empty it.
Moving the machine
If you have to move the machine (moving
house etc...):
1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge
hoses.
4. Pull the machine out together with the
hoses.
Avoid over tilting the machine during trans-
portation.
What to do if…
The appliance will not start or stops during
operation.
Certain problems can be due to the lack of
simple maintenance or oversights, which can
be solved with the help of the hints described
in the chart, without calling out an engineer.
Switch off the appliance and carry out the
following suggested corrective actions.
Fault codes and malfunction Possible cause and solution
•
digital display shows
The appliance does not fill with water
• The water tap is blocked or furred with lime-
scale.
Clean the water tap.
• The water tap is turned off.
Turn the water tap on.
• The filter (where present) in the water inlet hose
is blocked.
Clean the filter in the water inlet hose.
• The water inlet hose has not been correctly laid
or it is kinked or squashed.
Check the water inlet hose connection.
•
digital display shows
The appliance does not drain
• The sink spigot is blocked.
Clean out the sink spigot.
• The water drain hose has not been correctly laid
or it is kinked or squashed.
Check the water drain hose connection.
•
digital display shows
Anti-flood device is activated
• Close the water tap and contact your local
Service Force Centre.
Malfunction Possible cause and solution
The programme does not start
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set.
If dishes are to be washed immediately, cancel
the delay start.
18 electrolux