User manual

Attention! NOT all models of dish-
washers have fill and drain hoses
provided with a locknut. In this case,
this facility is not available.
If the machine is connected to new pipes
or pipes which have not been used for a
long time, you should run the water for a
few minutes before connecting the inlet
hose.
DO NOT use connection hoses
which have previously been used for
an old appliance.
This appliance has been fitted with
safety features which will prevent
the water used in the appliance from
returning back into the drinking wa-
ter system. This appliance complies
with the applicable plumbing regu-
lations.
Water inlet hose with safety valve
After connecting the double-walled wa-
ter inlet hose, the safety valve is next to
the tap. Therefore the water inlet hose is
only under pressure while the water is
running. If the water inlet hose starts to
leak during this operation, the safety
valve cuts off the running water.
Please take care when installing the wa-
ter inlet hose:
The electrical cable for the safety valve
is in the double-walled water inlet
hose. Do not immerse the water inlet
hose or the safety valve in water.
If water inlet hose or the safety valve
is damaged, remove the mains plug
immediately.
A water inlet hose with safety valve
must only be replaced by the Service
Force Centre.
Dangerous voltage
Water outlet hose connection
The end of the drain hose can be con-
nected in the following ways:
1. To the sink outlet spigot, securing it
to the underside of the work surface.
This will prevent waste water from
the sink running into the machine.
2. To a stand pipe provided with vent-
hole, minimum internal diameter 4
cm.
The waste connection must be at a
maximum height of 60 cm from the bot-
tom of the dishwasher.
36 electrolux water connection