User manual

- 6 -
Combination buttons ”A”
In addition to selecting a programme, you can press
these two buttons to adjust the setting of the water
softener, switch off the buzzer and rinse aid dispenser.
Control lamps:
Shows that • Refilling of salt is necessary
• Refilling of the rinse aid
is necessary
• Programme cycle ended
The control panel
Programme
buttons
Water softener
button
Buzzer
button
On/Off button
Delay start
button
Indicator lamps
delayed start
Control-
lamps
Switching the buzzer off
Before switching the buzzer off must all programmes have
completed.
1. Press in the On/Off button.
2. Press the combination buttons simultaneously
and hold them pressed in. When the first three
programme indicator lamps starts to flash, you
can let go of the buttons.
3. Press the buzzer button once. The lamp for
the buzzer button starts to flash and the lamp
for the ended programme cycle is lit. Press the
button once more and the lamp for the ended
programme cycle goes out. Now the buzzer is off.
4. Press out the On/Off button to complete the setting.
To reset the function, follow steps 1 and 2 above
and then press the buzzer button twice, until
the lamp for the ended programme cycle is lit
again.
Setting the delay start
The programme start can be delayed by 3, 6 or 9 hours.
1. Press in the On/Off button.
2. Press the delay start button repeatedly, until the
lamp next to the required hours of delay is lit.
3. Press the button for the required programme.
4. After the set delayed start time has elapsed,
the programme starts.
Reset the delayed start:
If the programme has not started, you can change
the set time with the delay start button.
Cancelling the delayed start:
If the programme has not started, the delayed
start can be cancelled. Press the delay start
button repeatedly, until none of the lamps next
to the hours are lit. The required programme
starts immediately.
A