User manual

11
Setting the amount of rinse aid required
3 Only change the amount dispensed, if smears,
milky spots (reduce the amount) or dried on
water spots (increase the amount) can be seen
on glasses and dishes. (See section “If dish-
washing results are not satisfactory”.) The
dosage can be set from 1-6. The dosage is
pre-set to “4” in the factory.
1. Open the dishwasher door.
2. Press the release button on the rinse aid compart-
ment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks into place.
6. If rinse aid has leaked out, wipe it away with a
cloth.
Activating/deactivating the inflow
of rinse aid
1. Press the ON/OFF button.
3 If indicators other than the cycle selection but-
ton are lit, a dishwashing cycle is activated.
The dishwashing cycle must be deselected:
Press function buttons 2 and 3 simultaneously
for approx. 2 seconds.
All other indicators will go out.
2. Press function buttons 2 and 3 simultaneously and
keep them pressed.
The LED indicators for function buttons 1 to 3 will
flash.
3. Press function button 2.
The LED indicator for function button 2 will flash.
The multi-display will indicate the current setting:
4. Pressing function button 2 activates and deacti-
vates the rinse aid dispensing function.
5. Once the multi-display is indicating the required
setting, press the ON/OFF button. The setting is
now saved.
0d Inflow of rinse aid is deactivated
1d
Inflow of rinse aid is activated (fac-
tory setting)