User manual

Cleaning the spray arms

Regularly check the nozzles in the three spray arms

for blockages. If necessary, clean the nozzles with a

piece of fine wire or a fine needle and a strong water

jet.

1 Do not damage the nozzle openings.

Top spray arm

1. Undo the fixing screw (A) by turning anti-clock-

wise.

2. Pull the spray arm off the shaft.

3. Clean the spray arm and the fixing screw.

4. Fasten the spray arm with the fixing screw (A) turn-

ing clockwise.

Middle spray arm

1. Remove the middle spray arm by turning it lateral-

ly.

The two-part spray arm bearing is held together by

a tension spring (B)

2. Clean spray arm nozzles.

3. To re-fit, press the middle spray arm upwards until

you feel it snap into place.

Lower spray arm

1. Undo the fixing screw (C) by turning anti-clock-

wise.

2. Pull the spray arm off the shaft.

3. Clean the spray arm and the fixing screw.

4. Fasten the spray arm with the fixing screw (C) turn-

ing clockwise.