User manual

21
Starting a dishwashing cy-
cle
1. Check that the spray arms can turn freely.
2. Turn the water tap on fully.
3. Press the ON/OFF button.
The LED for the cycle selection button will illu-
minate.
4. Select the desired cycle. In addition, press the cy-
cle selection button repeatedly until the de-
sired cycle is displayed in the multi-display (see
cycle table).
3 The cycle selected for the last dishwashing
session is displayed first.
5. Close the door. The dishwashing cycle will begin.
1 After the cycle has started, do not open the
door again, to prevent scalds and damage to
units from escaping steam. Only open the
door when the cycle has ended.
Half load additional function
Can be selected with the cycles: Intensive, Normal
Select this additional function when there are only
half the number of dishes.
1. After selecting the cycle, press the Half load
button.
The indicator for the Half load button will light
up.
2. When the cycle has finished, the Half load function
is automatically switched off again.
Antibac additional function
Can be selected with the cycles: Auto, Intensive,
Normal, Quick
This additional function makes it possible to thor-
oughly disinfect items such as baby bottles or jam
jars.
1. After selecting the cycle, press the Antibac
button
The indicator for the Antibac button will light
up.
In the last rinse cycle the temperature will now be
held at over 69 °C for at least 10 minutes.
2. When the cycle has finished, the Antibac function
is automatically switched off again.
Rinse + additional function
Can be selected with the cycles: Auto, Glasses, In-
tensive, Normal, Quick
If this additional function is selected, a second inter-
mediate rinse is performed.
1. After selecting the cycle, press the Rinse + but-
ton .
The indicator for the Rinse + button will light
up.
2. When the cycle has finished, the Rinse + additional
function is automatically switched off again.
Setting the Delay Timer
3 With the delay timer you can delay the start of
a dishwashing cycle for between 1 and 19
hours.
1. Press the Delay Timer button repeatedly until the
multi-display shows the desired time delay, for ex-
ample, 12h, if the cycle is to start in 12 hours. The
Delay Timer indicator is lit.
2. Select dishwashing cycle.
3. The time remaining until the start of the cycle is
continuously displayed (e. g., 12h, 11h, 10h, … 1h
etc.).
4. Close the door.
To change the delay timer:
As long as the cycle has not yet started, you can still
change the setting by pressing the Delay Timer but-
ton after opening the door.
Cancelling the delay timer:
Press the Delay Timer button repeatedly until the
number of the selected cycle appears in the multi-
display. The selected dishwashing cycle will begin
immediately.
To change a dishwashing cycle
As long as the cycle has not yet started, you can still
change the dishwashing cycle. First abort the dish-
washing cycle, then re-set the time delay, lastly se-
lect the new dishwashing cycle.
Indicator is lit:
Additional function
switched on
Indicator is not
lit:
Additional function
switched off
Indicator is lit:
Additional function
switched on
Indicator is not
lit:
Additional function
switched off
Indicator is lit: Rinse + activated
Indicator is not
lit:
Rinse + deactivated