User manual

14 www.electrolux.com
5. X-Fan function
6. I Favor function
The button is a shortcut button, users
could reserve the data of mode, fan
speed, set temperature, swing and when
pressing on it, it could operate in the
mode users set before.
a. Turn on the air conditioner, make
adjustment to the ideal mode you wanted.
b. Keep pressing the I Favor button for
three seconds, till the display screen give
the signal that represents the I Favor
button and glitter for three times, then
reserve the operation mode in the remote
controller, it’s done. To take place of the
previous operation mode, just do it as
shown above.
7. Sleep function
Press sleep button to enter sleep mode.
Then, in cool or heat mode, the set
temperature will increase(cooling) or
decrease(heating) by 1ºC(2ºF) over the
next 1 hour and by another 1ºC(2ºF)
after an additional 1 hour. The unit will
automatically exit sleep function when the
sleeping time is up to 7 hour. Unit will not
turn off.
Remark: press the MODE of ON/OFF
button, the remote controller clears
sleeping mode away.
8. Health function
Press the Health button to active the
health function. When the function
is initiated, the Ionizer/Plasma Dust
Collector(depending on models) is
energized and will help to remove pollen
and impurities from the air and I feel
function will be activated, at the same
time room temperature will automatically
change to 26ºC, I feel function can be
canceled by pressing I Feel button, also
room temperature setting be adjusted by
pressing
/ button. This function is
recommended when the indoor air quality
is in bad condition.
9. Wireless function
Continuous pressing Health button
8 times in 10s, then enter the
Wireless binding status.
• Please refer to the “Quick
Start Guide” for the Wireless
connection details.
In power on mode, press X-Fan button,
after 5 continuous rings the function will
activate successfully.
The indoor fan motor will keep on working
for 4 minutes after the unit turned off to
dry the indoor unit to prevent from bacteria
and mildew growing.
Continuous pressing the X-Fan button two
times, the function will be canceled after 3
continuous rings.
X-Fan function will keep active after
running once.