User manual
7 ENGLISH
4.2 Location of the Remote Controller
Fig.01
Max. 8m
• Keep the remote controller where its
signal can reach the receiver of the
indoor unit (a maximum distance of
8 m is allowed).
• If you keep the remote controller in
a position that hinders proper signal
transmission, a time lag of up to
15 minutes may occur.
• When the remote controller sends
out a signal, the symbol
will blink
for about 1 second on the display.
The indoor unit will acknowledge the
signal with a beep sound when it
receives an effective signal.
4.3 Battery installation/replacement
Fig.02 • Slide the battery compartment cover
off and insert two new alkaline dry
batteries (2x AAA 1.5 Volt). Make sure
that the polarity of (+) or (-) is installed
correctly.
• Slide the battery compartment cover
front on.
• When changing batteries, do
not use old or varied ones,
otherwise, it may cause
problems with the remote
controller.
• If the remote controller is not
used for a long time, remove
the batteries as old batteries
may leak or corrode and
damage the remote control.
• The battery life during normal
use is about six months.
• If the remote controller does
not operate normally, please
remove and ret the batteries. If
abnormal operation continues,
replace with new batteries.