User manual

9 ENGLISH
AUTO HIGHLOW MEDIUM
ON symbol ” ” blinks, press the UP
or DOWN button to set the time. Keep
the button pressed for two seconds to
accelerate the process. Press the button
to set the timer. Default setting: 8:00
(24-hour mode). Press the button again to
cancel the timer function.
TIMER OFF BUTTON
Press the button to set the timer function
for switching off the unit. If the TIMER
OFF symbol ”
” blinks, press the UP
or DOWN button to set the time. Keep
the button pressed for two seconds to
accelerate the process. Press the button
to set the timer. Default setting: 17:00
(24-hour mode). Press the button again to
cancel the timer function.
I FEEL BUTTON
Press the button to enable or disable the
I FEEL function. If the I FEEL function is
enabled, the I FEEL symbol ”
” will be
shown.
If the I FEEL symbol is enabled, the remote
control will send the ambient temperature
to the main unit every 10 minutes or when
you press one of the buttons.
FAN SPEED BUTTON
Press the button to set the fan speed:
AUTO, LOW, MEDIUM and HIGH. Default
setting: AUTO. In the DRY mode, only
LOW can be set.
TURBO BUTTON
In COOL or HEAT mode, press the button
to enable or disable the turbo function. If
the turbo function is enabled, the turbo
symbol ”
” will be shown.
If the turbo function is enabled, the unit
will operate at turbo speed to cool or heat
rapidly so that the ambient temperature
approaches the set temperature as soon
as possible.
CLOCK BUTTON (OPTIONAL)
Press the button to set the clock. If the
clock symbol ”
” blinks, press the UP
or DOWN button to set the time. Keep
the button pressed for two seconds to
accelerate the process. Press the CLOCK
button again to set the clock. The clock
symbol stops blinking.
HEALTH BUTTON (OPTIONAL)
Press the button to enable or disable the
operation of the health lter. If the HEALTH
function is enabled, the HEALTH symbol
”
” will be shown.
TEMP BUTTON
Press this button to change the Indoor
Unit temperature Display between Set
temperature and Room temperature.
After display Room temperature 5s, it
will turn into set temperature. Remote
controller display will always display Set
temperature.
When the symbol ”
” is shown, the indoor
unit displays the Set temperature.
When the symbol ” ” is shown, the indoor
unit displays the Room temperature.
LIGHT BUTTON
Press the button to switch the display
of the indoor unit on or off. When switch
on, the light symbol ”
” will be showed.
Default setting: OFF.
X-FAN BUTTON (OPTIONAL)
In COOL or DRY mode, press the button
to enable or disable the X-FAN function.
If the X-FAN function is enabled, the
X-FAN symbol ”
” will be shown. Default
setting: OFF.
ECO BUTTON
In COOL or DRY mode, press this button
to enable or disable Eco operation. If the
ECO function is enabled, the ECO symbol
”
” will be shown. Default setting: OFF.
This is ideal for the users to use while
sleeping.