User manual

35
Changing the opening direction of the
door
Unplug the freezer before performing the following
operations:
Remove the ventilation grid (C-Fig. 1).
Unscrew the bottom hinge (D-Fig. 1).
Remove the door from the upper pivot (A-Fig. 2).
Remove the pivot from the upper hinge (B), then
mount it on the opposite side.
Re-assemble the door.
Screw down the bottom hinge (D-Fig. 1) on the oppo-
site side by using the screws previously removed.
Detach the plug (E-Fig. 1) from the ventilation grid (C).
To do this, press it in the direction of the arrow.
Introduce the plug into the hole left free on the oppo-
site side.
Re-assemble the ventilation grid.
Take off the handle cover (see Fig. 3), reverse the di-
rection of the handle.
The unused opening direction is concealed by plastic
plugs. Therefore, these plugs are to be mounted on
the holes left free.
Aligning the worktop of the appliance with
the kitchen furniture
The appliance worktop is aligned with the door.
It can however be easily aligned to the kitchen furni-
ture by proceeding as follows:
unscrew the screws on the upper hinges that fasten
the worktop to the appliance.
Move the worktop to the desired position and tighten
the screws again.
Fig. 1
Fig. 2
Fig. 3
E
D
C
E
E
D229
B
A
D230
B0646