User manual

Door reversal

Before starting work, unplug the appliance. To reverse

the opening direction of the door proceed as follows:

remove the lower hinge (3), pin (1) and foot (2);

unscrew the front left foot and screw it back in on the

opposite side;

remove the two screws which mask the holes for ﬁx-

ing the hinge from the front left hand side;

slide out the door from pin (5), unscrew the latter and

then screw it down into the hinge provided on the op-

posite side;

remove the two plugs, to reveal the holes for the hinge

pivots, and remount them on the other side;

reassemble the door;

reﬁt the lower hinge (turning it through 180°), the pin

and the foot on the opposite side, as shown in the ﬁg-

ure.

Unscrew the handle. Reﬁt it on the opposite side after

having pierced the plugs with a punch. Cover the

holes left open with the plugs contained in the docu-

mentation pack.

Attention

After having reversed the opening direction of the

door check that all the screws are properly tight-

ened and that the magnetic seal adheres to the

cabinet. If the ambient temperature is cold (i.e. in

Winter), the gasket may not ﬁt perfectly to the cabinet.

In that case, wait for the natural ﬁtting of the gasket or

accelerate this process by heating up the part in-

volved with a normal hairdrier.

Fig. 3

Fig. 4

Fig. 5

D548

180°

D299

PR228