User manual

11
Fijar el aparato con los 4 tornillos en dotación.
(I = corto) (P = largo)
D724
Colocar a presión el cubrejuntas entre el aparato y
el mueble.
I
P
B
E
C
D
Colocar les tapas (C-D) sobre los extremos del perfil
y en los agujeros para la bisagra.
Colocar la parrilla de aireación (B) encajándola a
presión y engornar la tapa (E) en posición.
PR266
Ha
Hb
Hc
Hd
2
1
m
m
2
1
m
m
ca. 50 mm
90°
90°
ca. 50 mm
Separar las piezas Ha, Hb, Hc, Hd según se indica
en la figura.
Apoyar la guía (Ha) sobre la parte interior de la
puerta del mueble arriba y abajo según se indica en
la figura y marcar la posición de los agujeros
exteriores. Una vez que se hayan hecho los
agujeros, fijar la guía con los tornillos presentes en
el equipo base.
14
CONTENTS
Warnings 13
Use 15
Cleaning the interior 15
Control panel 15
Display 15
Operation 16
Activation of function 16
Switching off 16
Temperature regulation 16
Freezing fresh food 16
Storage of frozen food 16
Excessive temperature alarm 17
Door open acoustic alarm 17
Thawing 17
Ice-cube production 17
Cold accumulator 17
Hints 18
Hints for freezing 18
Hints for storage of frozen food 18
Maintenance 19
Periodic cleaning 19
Periods of no operation 19
Defrosting 19
Customer service and spare parts 19
Technical information 19
Installation 20
Location 20
Electrical connection 20
Door Reversibility 20
Instruction for totally built-in appliances 21
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials.The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities.The materials used on this appliance
marked by the symbol are recyclable.
Disposal of old Appliances
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it shall be handed over to
the applicable collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help prevent
potential negative consequences for the
environment and human health, which could
otherwise be caused by inappropriate waste
handling of this product. For more detailed
information about recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased
the product.
Installation
• During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the instructions.
Attention: keep ventilation openings clear of
obstruction.
• Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Important: if the supply cord is damaged, it must
be replaced by a special cord or assembly availa-
ble from the manufacturer or its service agent.
• If the appliance is transported horizontally, it is
possible that the oil contained in the compressor
flows in the refrigerant circuit. It is advisable to
wait at least two hours before connecting the
appliance to allow the oil to flow back in the
compressor.
• There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
• Parts which heat up should not be exposed.
Wherever possible the back of the product should
be against a wall.