User manual

Door reversal
The appliance must be unplugged before starting
work. To reverse the opening direction of the door,
proceed as follows:
1. Remove the top hinge (1) taking care not to let the
door fall.
2. Remove the bottom door hinge (2).
3. Take out the plugs (3) from the holes (F) and
reinsert them in the holes (F
1
) on the opposite side.
4. Refit the upper hinge (1) on the opposite side, on
the bottom (position A).
5. Refit the door on the pin of the hige (1) in position
A;
6. Insert the pin of the previously removed bottom
hinge (2) in the upper hole (G) of the door,
therefore fix the hinge on the top in position B.
Building in the appliance under a
worktop
The dimensions of the recessed installation area must
correspond with those indicated in the figure. The
appliance could be inserted between two units (a) or
as an end unit (b).
Important
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.
Fasten the side panel to the rear of the appliance with
the fixing brackets.
11
S.I.003
F
F
B
A
F
3
1
2
G
1
F
1
S.I.004
600
550
600
600
820 - 870
b
a
S.I.005
D326
SUPER.
INFER.
UPPER
LOWER