User manual

Problem Possible cause Remedy
The oven does not heat
up.
The fuse is blown. Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
The lamp does not oper‐
ate.
The lamp is defective. Replace the lamp.
The display does not show
the time during the off sta‐
tus.
The display is deactivated.
Touch and at the
same time to activate the
display again.
The core temperature sen‐
sor does not operate.
The plug of the core tem‐
perature sensor is not cor‐
rectly installed into the
socket.
Put the plug of the core
temperature sensor as far
as possible into the socket.
It takes too long to cook
the dishes or they cook too
quickly.
The temperature is too low
or too high.
Adjust the temperature if
necessary. Follow the ad‐
vice in the user manual.
Steam and condensation
settle on the food and in
the cavity of the oven.
You left the dish in the
oven for too long.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the
cooking process ends.
The display shows "C2". You want to start the De‐
frost function, but you did
not remove the core tem‐
perature sensor plug from
the socket.
Remove the core tempera‐
ture sensor plug from the
socket.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. • Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service
centre is on the rating plate. The rating
plate is on the front frame of the
appliance cavity. Do not remove the
rating plate from the appliance cavity.
ENGLISH 41