User manual

Problem Possible cause Remedy
The display shows "C2". You want to start the De‐
frost function, but you did
not remove the core tem‐
perature sensor plug from
the socket.
Remove the core tempera‐
ture sensor plug from the
socket.
The display shows an error
code that is not in this ta‐
ble.
There is an electrical fault. • Deactivate the oven
with the house fuse or
the safety switch in the
fuse box and activate it
again.
• If the display shows the
error code again, con‐
tact the Customer Care
Department.
The descaling procedure is
interrupted before it finish‐
es.
There was a power cut. Repeat the procedure.
The descaling procedure is
interrupted before it finish‐
es.
The function was stopped
by the user.
Repeat the procedure.
There is no water inside
the grill- / roasting pan af‐
ter the descaling proce‐
dure.
You did not fill the water
drawer to the maximum
level.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The grill- / roasting pan is
on a wrong shelf position.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roast‐
ing pan on the first shelf
position.
The cleaning function is in‐
terrupted before it finishes.
There was a power cut. Repeat the procedure.
The cleaning function is in‐
terrupted before it finishes.
The function was stopped
by the user.
Repeat the procedure.
There is too much water on
the bottom of the cavity af‐
ter the end of the cleaning
function.
You sprayed too much de‐
tergent in the appliance
before the activation of the
cleaning cycle.
Cover all parts of the cavity
with a thin layer of the de‐
tergent. Spray the deter‐
gent evenly.
There is no good perform‐
ance of the cleaning proce‐
dure.
The initial oven cavity tem‐
perature of the steam
cleaning function was too
high.
Repeat the cycle. Run the
cycle when the appliance
is cold.
www.electrolux.com44