User manual

We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
14. INSTALLATION
WARNING!
Refer to Safety chapters.
14.1 Building in
The built-in unit must meet
the stability requirements of
DIN 68930.
The oven is designed to be connected to
230 - 240 V ~ (50 Hz) electricity supply.
The oven has an easily accessible terminal
block which is marked as follows:
Letter L - Live terminal
Letter N - Neutral terminal
- Earth terminal
CAUTION!
This oven must be earthed!
The cable used to connect the oven to the
electrical supply must comply to the
specifications given below.
For UK use only
Connection via Min. size cable /
flex
Cable / flex type Fuse
Cooker Control Cir-
cuit
2,5 mm² PVC / PVC twin and
earth
min: 15 A
max: 20 A
It is necessary that you install a double
pole switch between the oven and the
electricity supply (mains), with a minimum
gap of 3 mm between the switch contacts
and of a type suitable for the required load
in compliance with the current regulations.
The switch must not break the yellow and
green earth cable at any point.
After installation and
connecting, the cable must
be placed so that it cannot at
any point reach a
temperature of more than
50°C above the ambient
temperature.
Before the oven is
connected, check that the
main fuse and the domestic
installation can support the
load; and that the power
supply is properly earthed.
The manufacturer declines any
responsibility should these safety
measures not be carried out.
www.electrolux.com42