Service manual

Notice
Date Page
01201090
INSTRUCTION
HANDBOOK
Drain connection
The machine's exhaust sleeve is outside diameter 110 mm (4.33"). It is located underneath the
machine.
The waste water collector diameter 200 mm (7.87") (manufactured by customer) should have a
3 cm/m (3 %) slope and resist to a temperature of 90°C (194°F). It should be connected to the
waste water general network in accordance with local codes and regulations.
Adapt and connect the machine's exhaust sleeve to the waste waters' collector (rubber bend
and connection nozzle are supplied in the machine with collars).
Drawing of drain connection to waste waters' collector
Connect the durit to the connect nozzle.
Put them both in the 300 x 300 mm (12x12") hole.
Seal and fix the nozzle in the hole using 2 screws.
Them connect the durit to the drain's evacuation sleeve.
9. Installation
0102 8
9
D0647
Connection durit
Connection nozzle
Waste water collector
Drain's evacuation sleeve
100
120
Ø 110
Ø 200
300 x 300
290 x 290