WASHING MACHINE TVÄTTMASKIN PYYKINPESUKONE STIRALWNAÅ MAfiINA INSTRUCTION BOOKLET BRUKSANVISNING KÄYTTÖOHJE RUKOVODSTVO PO ÈKSPLUATACII EWS 1030 EWS 1230 GB S FI N 132 990 762 Downloaded From WashingMachine-Manual.
Dear customer, Transport damages Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. • Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry. Installation • All internal packing must be removed before using the appliance. Serious damage may be caused to the machine or adjacent furniture if the protective transit devices are not removed or are not completely removed.
Disposal Machine Packaging materials The materials marked with the symbol recyclable. Use authorised disposal sites for your old appliance. Help to keep your country tidy! are >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet. Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. P1128 P0002 Positioning Install the machine on a flat hard floor.
The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks The drain hose must not be kinked. P1118 For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance. P0021 The inlet hose must not be lengthened.
This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. • The automatic cooling of the washing water from 95° to 60°C before draining will prevent old drain pipes from being deformed. • The special wool programme with its new delicate wash system treats your woolens with extreme care. • The unbalance detection device prevents vibration during spinning.
Use Control panel 1000 900 700 500 + T IME L IN E EWS 1030 12 3 4 5 6 7 8 9 10 11 13 14 12 At the end of the programme the selector dial must be turned to position O. 1 Programme chart A programme chart in English is in the interior part of the detergent dispenser drawer or together with the instruction booklet.. Programme Option buttons Press this button to switch the machine on. Press it again to switch the machine off. Depending on the programme, different functions can be combined.
By selecting this option the spinning phases are suppressed. To be selected for all the programmes. If you select this option with programmes for cotton and synthetics, the machine will perform some extra rinses. The wash programme can be delayed from 30 min – 60 min – 90 min, 2 hours and then by 1 hour up to a maximum of 23 hours by means of this button. Selecting the delayed start • Select the programme and the required options. • Select the delay start.
The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute. End of programme When the programme has finished a flashing zero is displayed. Delayed start The selected delay (23 hours max) set by means of the relevant button appears on the display for 3 seconds, then the duration of the previously selected programme is displayed. The countdown is updated every hour.
ENGLISH 14 Programme progress display By selecting the wash programme, the pilot lights corresponding to the various phases making up the programme come on. After the machine has started, only the running phase pilot light stays on. When the programme has finished, the End pilot light comes on. The END pilot light flashes in the event of operating problems. At the same time an alarm code appears on the display.
Programme information / D = Delicate spin Wool/Handwash Separate short spin at the maximum speed 700 rpm for hand washed garments. It has to be used for synthetic, delicate, wool/handwashed, silk items. You can reduce the speed by means of button to adapt it to the fabrics to be spun. Washing programme for machine washable wool as well as for hand washable woolens and delicate fabrics with the “handwashing” care symbol. 60° O = Cancelling and 40° To reset a programme turn the selector dial to O.
Laundry weights The following weights are indicative: Sorting the laundry bathrobe Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens.
Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. Quantity of detergent to be used The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used. Tar stains: first treat with stain remover, methylated spirits or benzine, then rub with detergent paste.
4. Switch the machine on To switch the machine on, press the ON/OFF button: the mains-on light comes on. Before the first wash we recommend that you pour 2 litres of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine. --0 1. Open the door.
7. Select the required options 10. Changing an option or a programme during its cycle The light corresponding to the depressed button illuminates. It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing the START/PAUSE button. Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position.
These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash 95 60 40 30 Max. wash temperature 95°C Max. wash temperature 60°C Max. wash temperature 40°C Max.
Programme chart Washing programmes Temp. 60°- 95° E60°** 30°- 60° 60° - 40° E40° 40°AA*** -30°-60° Type of fabric Programme description Additional functions Max. load Water lt. Time min. Wash at 60°- 95°C 3 rinses Normal spin 4 kg 1.8 47 145 White cotton economy Wash at 60°C 3 rinses Normal spin 4 kg 0.76 44 130 Coloureds Wash at 30°-60°C 3 rinses Normal spin 4 kg 1.0 44 110 Whites and Coloureds Wash at 40°-60°C 3 rinses Normal spin 4 kg 1.
ENGLISH Programme chart Special programmes Selector dial position A Programme Programme description Additional functions Max. load Consumption* Energy kWh Water lt. Time min. Rinses 3 rinses with liquid additives if required Long spin 4 kg 0.05 42 45 Drain For emptying out the last rinse of the programmes with option / - - 3 C Spin Drain and long spin 4 kg - - 10 D Delicate spin Drain and delicate spin 1.
Maintenance Detergent can also accumulate inside the drawer recess: clean it with an old toothbrush. Refit the drawer after cleaning. Bodywork Clean the outside of the machine with soap and water only. Rinse with clean water and dry with a soft cloth. Important: do not use methylated spirits, solvents or similar products to clean the bodywork. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold.
If the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the water has cooled down; • open the pump door; • place a bowl on the floor and place the end of the emergency emptying hose into the bowl. Remove its cap. The water should drain by gravity into the bowl. Whe the bowl is full, put the cap back on the hose. Empty the bowl.
Something not working? Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display and at the same time the light starts to flash: - E10 : problem with the water supply - E20 : problem with water draining - E40 : door open Once the problem has been eliminated, press the START/PAUSE button to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
Possible cause • The door will not open: • • • • The programme is still running. The door lock has not yet released. The water level is above the bottom edge of the door. The machine is heating the water. • Spinning starts late or the laundry is not spun enough: • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum.
The Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.14 billion USD in more than 150 countries around the world. MADE IN EEC Downloaded From WashingMachine-Manual.
