User Manual

ManualsBrandsElectrolux ManualsDomestic AppliancesEW1200I

Water drainage

This appliance is designed to be permanently plumbed

into your home's water supply and drainage system.

The appliance drain hose should hook into a standpipe,

the hook in the drain hose is formed using the plastic

“U-Piece” supplied.

The standpipe should have an internal diameter of

approximately 38mm (see diagram) thus ensuring there

is an air break between the drain hose and standpipe.

When discharging into a standpipe ensure that the top of

the curve in the hose end is no more than 90cm (35.4'')

and no less than 60cm (23.6'') above floor level. The

upright standpipe should have a minimum length of

30cm (12'') from the bottom of the elbow to the top of

the pipe (see diagram).

Make sure that it is designed in such a way, that the end

of the drain hose cannot be covered with water.

The drain hose may be extended to a maximum of 4

metres. An additional drain hose and joining piece

is available from your local Service Force Centre.

The joining piece must have an internal diameter of

18mm.

If you intend the drain hose to empty into a sink, make

sure that the sink is empty and the plug hole is not

blocked. Use the plastic “U-Piece” supplied.

Important

Before connecting up the machine to new pipework or

to pipework that has not been used for some time, run

off a reasonable amount of water to flush out any debris

that may have collected in the pipes.

Levelling

Level the washing machine by raising or lowering the

feet. The feet may be tight to adjust as they incorporate

a self locking nut, but the machine MUST be level.

Any necessary adjustment can be made with a spanner.

Accurate levelling prevents vibration, noise and

displacement of the machine during operation.

Some vibration is inevitable, especially if mounted on a

wooden floor.

Sprung wooden floors are particularly susceptible to

vibration. For advice, consult a builder. If possible,

always place the machine on a solid floor.

P0850

P0022

P1039

3 pin

Max. 90 cm.(35.4")

Min.60 cm.

(23.6")

P1040

Min. 30 cm.(12")

38 mm.(1/ ") diameter

standpipe