User manual

8. The dangers of freezing

If the machine is exposed to temperatures below

0°C, certain precautions should be taken.

Turn off the water tap.

Unscrew the inlet hose.

Place the end of the inlet hose and that of the

emergency emptying hose in a bowl placed on the

floor and let the water drain out.

Screw the water inlet hose back on and put the

emergency emptying hose back in its place after

having screwed the cap on again.

When you intend to start the machine up again,

make sure that the room temperature is above 0°C.

6. Water inlet filter

If you notice that the machine is taking longer to fill,

check that the filter in the water inlet hose is not

blocked.

Turn off the water tap.

Unscrew the hose from the tap.

Clean the filter with a stiff brush.

Refit the filter and screw the hose back onto the tap.

7. Emergency emptying out

If the machine is unable to drain, proceed as follows

to empty out the machine:

• pull out the plug from the power socket;

• close the water tap;

• if necessary, wait until the water has cooled down;

• place a bowl on the floor under the filter and place

the end of the emergency emptying hose into the

bowl. The water should drain by gravity into the

bowl. When the bowl is full, screw the cap on

again. Empty the bowl. Repeat the procedure until

water stops flowing out;

• at the end screw the filter again.

P1090

132993580•EW1220/1620N•gb 07/07/03 11:22 Pagina 22