User manual
82
Building-in
This appliance has been
designed to be built into
the kitchen furniture.
The recess should have
the dimensions shown in
the picture (Fig. A).
Preparation and assembly of the door
The machine is originally pre-arranged for assembly
of a door opening from right to left.
In this case it is suffi-
cient to screw-in on the
door the two hinges (1)
and the counter-magnet
(5) in the right position
(Fig. B).
a) Door
The dimensions of the door should be:
width 595 to 598 mm
thickness 16 to 22 mm
The height (C) cannot be given, since it depends on
the height of the adjacent furniture, e.g. height of the
kick plate of the kitchen unit.
b) Hinges
To mount the hinges on
the door it is necessary
to drill 2 holes (dia.
35 mm, depth 14 mm) on
the door’s inner side.
The distance between
the holes must be
416 mm.
The dimension (B) (from
upper edge of the door
to the centre of the hole)
cannot be given, since it depends on the adjacent
cabinet’s dimensions.
The required dimensions are given in the picture
(Fig. C).
The hinges will be fixed to the door by means of self-
tapping screws (Fig. B/2).
c) Mounting the door (Fig. B)
Fix the hinges to the machine by means of M5x8 mm
screws (3).
To compensate for possible uneven thickness of the
door the hinges can be adjusted horizontally.
To align the door perfectly it may sometimes be
necessary to adjust the hinge (1).
To do this unscrew the screw (3), align the door and
then retighten the screw (3).
d) Counter-magnet
The door is kept closed
by a magnetic closure.
To enable the closure to
operate, a counter-
magnet (5) must be
screwed into the door
inner side (steel disk with
rubber ring). See Fig. B.
Its position must correspond with the magnet (4) on
the appliance (see Fig. D).
To assemble a door
opening from left to
right operate as follows:
Fit the plates (2) on the
right side and the
magnet (4) on the left
side. Mount the counter-
magnet (5) and the hin-
ges (1) on the door inner
side. See Fig. E.
600
820
600
P0118
4
1
2
3
5
1
2
3
P0806
HOLE DIA. 35 mm - Depth 14 mm
16-22
B
C
22+1,5
595-598
416
P0026
P0027
4
1
2
3
5
1
2
3
P0807
A
B
C
D
E