32989041-COPERTINA.qxd 17/06/05 10.
132989041.qxd 21/06/2005 11:51 Pagina 2 (Nero/Process Black pellicola) Dear customer, Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. Transport damages When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
132989041.
132989041.qxd 21/06/2005 11:51 Pagina 4 (Nero/Process Black pellicola) Warnings The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. • Use only the recommended quantities of fabric softener. An excessive amount could damage the laundry. Installation • All internal packing must be removed before using the appliance.
21/06/2005 11:51 Pagina 5 (Nero/Process Black pellicola) To disable this device and restore the possibility of closing the door, rotate the button anti-clockwise until the groove is vertical. Child safety • Children are often not aware of how dangerous electrical appliances can be. When the machine is working, children should be carefully supervised and not be allowed to play with the appliance. • The packaging components (e.g.
132989041.qxd 21/06/2005 11:51 Pagina 6 (Nero/Process Black pellicola) Technical specifications DIMENSIONS Height Width Depth MAXIMUM LOAD Cotton Synthetics Delicates Woollens 85 cm 60 cm 61 cm WASHING 7 kg 3 kg 3 kg 2 kg DRYING 3 kg 2 kg - SPIN SPEED 1200 rpm max.
132989041.qxd 21/06/2005 11:51 Pagina 7 (Nero/Process Black pellicola) ENGLISH Installation 5 Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. A 4 P1204 1. Using a spanner, unscrew and remove the two rear bottom screws. Slide out the two plastic pins. P1205 7. Set the machine upright and remove the remaining rear screw.
132989041.qxd 21/06/2005 11:51 Pagina 8 (Nero/Process Black pellicola) The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised. Water inlet Connect the water inlet hose to a tap with a 3/4" thread. Do not use already employed employed hoses. The other end of the inlet hose which connects to the machine can be turned in any direction.
132989041.qxd 21/06/2005 11:51 Pagina 9 (Nero/Process Black pellicola) This new machine, which is fitted with the New Jet System, patented Electrolux, meets all modern needs for effective treatment of laundry with low water, energy and detergent consumption. Further savings are achieved by washing small loads of laundry, since water and electricity consumption is proportional to the quantity and type of laundry being washed.
132989041.
21/06/2005 11:52 Pagina 11 (Nero/Process Black pellicola) To complete the cycle, choose one of the following options: 7 Electronic Drying button • Draining and spin: By means of this button you can choose the required degree of drying for cottons and synthetics: - Press the START/PAUSE button. The machine will drain the water, then spin the laundry at the maximum speed provided for the performed programme. Extra dry (cottons). Store dry (cottons and synthetics). Iron dry (cottons).
132989041.qxd 21/06/2005 11:52 Pagina 12 (Nero/Process Black pellicola) • Duration of washing programme in hours and minutes, after you have selected a programme. While the programme is running (after you have pressed the START/PAUSE button), the displayed time value decreases by one unit every minute. the manufacturer’s inspection tests, and this cycle has not been erased after its completion. • Delay start, a time value indicated in hours and selected by means of the relevant button.
21/06/2005 11:52 Pagina 13 (Nero/Process Black pellicola) - press the SKIP/RESET button once or several times, until the required phase(s) is(are) cancelled (the light next to the name of the phase(s) will go out). 10 START/PAUSE button This button has three functions: • Start: after you have selected the desired programme and options, press this button to start the machine. The light above the button will stop flashing and remain lit.
132989041.qxd 21/06/2005 11:52 Pagina 14 (Nero/Process Black pellicola) • If the machine is switched off: 13 Programme phase indicator lights - depress ON/OFF button to switch it on; - select the type of fabric by means of FABRICS button ; When you select a programme, the lights relevant to the phases that form the programme light up. - select the special programme as previously described.
21/06/2005 11:52 Pagina 15 (Nero/Process Black pellicola) Laundry weights Washing hints The following weights are indicative: Sorting the laundry bathrobe Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens.
132989041.qxd 21/06/2005 11:52 Pagina 16 (Nero/Process Black pellicola) residual marks with bleach. Quantity of detergent to be used Ink: depending on the type of ink, moisten the fabric first with acetone (*), then with acetic acid; treat any residual marks on white fabrics with bleach and then rinse thoroughly. The type and quantity of detergent will depend on the type of fabric, load size, degree of soiling and hardness of the water used.
21/06/2005 11:52 Pagina 17 (Nero/Process Black pellicola) Drying symbols on garment labels Drying hints Always look at the garment label to check whether garments can be machine dried. As a dryer, the machine works on the condensation principle. The following symbols refer to drying: Therefore, the water tap must be open and the drain hose must drain water into a sink or into the drain pipe, even during the drying cycle.
132989041.qxd 21/06/2005 11:52 Pagina 18 (Nero/Process Black pellicola) 4. Switch the machine on Operating sequence Press the ON/OFF button to switch the machine on. The display will show three blinking dashes or a blinking zero. The light above the button will light up. Washing only Before washing your first load of laundry, we recommend that you run a cotton cycle at 95°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub.
21/06/2005 11:52 Pagina 19 (Nero/Process Black pellicola) 6. Select the temperature 9. Select the DELAY TIME Press the TEMPERATURE button if you wish to select a temperature value different from the one proposed by the machine or the (COLD WASH). The relevant light will light up. Before you start the programme, if you wish the starting to be delayed, press the DELAY button repeatedly, or keep it pressed, to select the desired delay.
132989041.qxd 21/06/2005 11:52 Pagina 20 (Nero/Process Black pellicola) After approximately 3 minutes, you can open the door. Pay attention to the level and temperature of the water in the machine! When you close the door and press the ON/OFF button again, the machine will resume the programme from the point where it had been interrupted. 11. How to change a programme during its cycle Before you make any change, you must pause the machine by pressing the START/PAUSE button.
/06/2005 11:52 Pagina 21 (Nero/Process Black pellicola) 4. Press the START/PAUSE button to start the programme. Drying 3 kg of cotton You have for example just machine-washed and spun at 1200 rpm 6 kg of laundry. They are cotton fabrics of medium weight which you want to iron as soon as they are dry. Press the SKIP/RESET button repeatedly to erase the programme that has just been carried out, the display will show 3 dashes and switch the machine off by depressing ON/OFF button.
132989041.qxd 21/06/2005 11:52 Pagina 22 (Nero/Process Black pellicola) Programme table Washing programmes Type of laundry and symbols on labels 60 95 White cotton: e.g. sheets, tablecloths, household linen 60 40 30 Max. load Programme/ temperature 7 kg Cottons 60°-95°C 7 kg 40 30 30 30 Time h/min. 53 2.30 Cottons 60°-40°-30°C (cold) Wash at 60°-40°-30°C or 3 rinses Long spin SPIN SPEED RINSE HOLD PREWASH EXTRA RINSE EXTRA QUICK 1.19 49 2.
132989041.qxd 21/06/2005 11:52 Pagina 23 (Nero/Process Black pellicola) ENGLISH Programme table Timed drying Degree of drying Extra dry Ideal for towelling materials Store dry Suitable for items to put away without ironing Iron dry Suitable for ironing Type of fabric Cotton and linen (bathrobes, bath towels, etc.) Cotton and linen (towels, T-shirts, bathrobes) Synthetics and mixed fabrics (jumpers, blouses, underwear, household linen) Cotton and linen (sheets, tablecloths, shirts, etc.
132989041.qxd i 21/06/2005 11:52 Pagina 24 (Nero/Process Black pellicola) International wash code symbols These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash 95 60 40 30 Max. wash temperature 95°C Max. wash temperature 60°C Max. wash temperature 40°C Max.
132989041.qxd 21/06/2005 11:52 Pagina 25 (Nero/Process Black pellicola) 1. Door seal 4. Drain pump Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold. The pump should be inspected if • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: • Disconnect the appliance.
132989041.qxd 21/06/2005 11:52 Pagina 26 (Nero/Process Black pellicola) • Put the cap back on the emergency emptying hose and place the latter back in its seat. 6. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: • pull out the plug from the power socket; • close the water tap; • if necessary, wait until the water has cooled down; • open the the pump door; • place a bowl on the floor and place the end of the emergency emptying hose into the bowl.
132989041.qxd 21/06/2005 11:52 Pagina 27 (Nero/Process Black pellicola) Problems which you can resolve yourself. During machine operation it is possible that one of the following alarm codes appears on the display: - E10 : problem with the water supply - E20 : problem with water draining - E40 : door open Once the problem has been eliminated, press the START/PAUSE button all checks, the problem persists, contact your local Service Centre. Problem to restart the programme.
132989041.qxd 21/06/2005 11:52 Pagina 28 (Nero/Process Black pellicola) Problem Possible cause • Spinning starts late or the laundry is not spun enough: • The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
132989041.
