Use & Care Guide Warm & Serve Drawer 318 201 023 (0809) Rev.
Finding Information MAKE A RECORD FOR FUTURE USE Brand ____________________________________________________________ Purchase Date ____________________________________________________ Model Number _____________________________________________________ Serial Number _____________________________________________________ NOTE The serial and model numbers are available on the serial plate located on the right side of the drawer frame. QUESTIONS? For toll-free telephone support in the U.S.
Safety IMPORTANT SAFETY INSTRUCTIONS Please read all safety instructions before using your new Electrolux Warm & Serve Drawer. ! WARNING To reduce the risk of fire, electrical shock, or injury when using your Warm & Serve Drawer, follow basic precaution including the following: • • Remove all tape and packaging wrap before using the appliance. Destroy the carton and plastic bags after unpacking the appliance. Never allow children to play with packaging material. Proper Installation.
Safety • • • • • • • • • • • Do not leave children alone. Children should not be left alone or unattended in the area where an appliance is in use. They should never be allowed to sit or stand on any part of the appliance. DO NOT TOUCH INTERIOR SURFACES OF THE WARMER DRAWER. Surfaces may be hot even though they are dark in color. During and after use, do not touch, or let clothing or other flammable materials touch these areas until they have had sufficient time to cool.
Setting Control 5 BEFORE SETTING WARMER DRAWER CONTROL Arranging Warmer Drawer Rack Positions Set the warmer drawer rack in the vertical position as shown below. The rack can be used in 2 ways: • In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish under).
Setting Control SETTING WARMER DRAWER CONTROLS To Set the Controls The digital controls are used to set the temperature of the warmer drawer. It is located at the right side of the warmer drawer in the open position. To Power-Up the Controls On the first power-up or after a power interruption, the unit will flash “88:88°” in the display. Press the ON-OFF pad twice. The display will show “----”, prompting to press another pad. If no other pad is touched, the unit will power off after a few seconds.
Setting Control SETTING HUMIDITY CONTROLLER To Set the Humidity Controller The humidity controller is located on the inside of the warmer drawer and used to control humidity in the warmer drawer. The humidity control knob can be set at any position between Moist (Figure 1) and Crispy (Figure 2) position. To set the humidity controller, slide the humidity control knob to the desired location.
General Care & Cleaning TO REMOVE AND REPLACE WARMER DRAWER ! Lever Left glide Pull down lever with finger Lever Pull up lever with finger WARNING Turn the warmer drawer to OFF before removing the drawer. DO NOT touch the warmer drawer element. The element may still be hot enough to cause burns, even if it is dark in color. Figure 1 Right glide To Remove Warmer Drawer: 1. Turn power off before removing the warmer drawer. 2. Open the drawer to the fully opened position. 3.
General Care & Cleaning 9 CARE & CLEANING TABLE Cleaning Various Parts or Your Appliance Before cleaning any part of the drawer, be sure control is turned OFF and the drawer is COOL. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS WILL REDUCE THE NUMBER OF MAJOR CLEANINGS LATER. Surfaces How to Clean Plastic Membrane Keypad Clean with a cloth soaked in soapy water. Rinse with a clean water and a dishcloth. Note: Humidity controller knob can not be removed.
Solutions to Common Problems IMPORTANT Before calling for service, review this list. It may save you both time and expense. This list includes common experiences that are not the result of defective workmanship or material in your Warm & Serve Drawer. DRAWER IS NOT LEVEL • Poor installation. Place a level on the cutout bottom. Make sure bottom is level. • Be sure cutout bottom is strong and stable enough to adequately support drawer (and wall oven, if applicable).
Notes 11
Major Appliance Warranty Information Your appliance is covered by a one year limited warranty. For one year from your original date of purchase, Electrolux will repair or replace any parts of this appliance that prove to be defective in materials or workmanship when such appliance is installed, used, and maintained in accordance with the provided instructions.