Installation Guide

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
15
Figure 21
BACK EDGE OF
RANGE LINE OR
REAR WALL
REAR WALL
ANTI-TIP
BRACKET
C
L
10 ”½
(26.7 cm)
To e
Plate
Door
Cabinet
Kitchen
Cabinet
SLIDE
BACK
1. Draw a center line (CL) on the oor where the range
should be installed. Also draw a line on the oor at the
range back position if there is no wall.
2. Unfold paper template and place it at on the oor
with the right rear corner positioned exactly on the
intersection of the center and back lines you just drew
before. (Use the diagram below to locate brackets if
template is not available (Figure 21)).
3. Mark on the oor the location of the 4 mounting holes
shown on the template. For easier installation, 3/16"
(0,48 cm) diameter pilot holes 1/2" (1,27 cm) deep can
be drilled into the oor.
4. Remove template and place bracket on oor. Line up
holes in bracket with marks on oor and attach with
4 screws provided. Bracket must be secured to solid
oor (Figure 22). If attaching to concrete oor, rst drill
3/16" (0,48 cm) dia. pilot holes using masonry drill bit.
5. Be sure the 4 levelling legs are at the highest position
they can be.
6. Slide range into place making sure structure of the
range is trapped by the anti-tip bracket (Figure 21).
Lower the range by adjusting the 4 levelling legs until
the underside of the cooktop is sitting level on the
countertop. Refer to "Levelling the Range" section.
7. After installation, verify that the anti-tip bracket is
engaged by grasping the top rear edge of the range
and carefully attempt to tilt it forward to make sure
range is properly anchored.
12
Anti-Tip Brackets Installation
Instructions
12.1
Models Equipped with Leveling Device
To reduce the risk of tipping of the
range, the range must be secured to the oor by
properly installed anti-tip bracket and screws packed
with the range. These parts are located in the oven.
Failure to install the anti-tip bracket will allow the range
to tip over if excessive weight is placed on an open door
or if a child climbs upon it. Serious injury might result
from spilled hot liquids or from the range itself.
Follow the instructions below to install the anti-tip
brackets.
If range is ever moved to a different location, the anti-
tip brackets must also be moved and installed with the
range.
Tools Required:
Adjustable Wrench
Ratchet
Drill & 1/8" (0,32 cm) bit
5/16" (0,8 cm) Nutdriver
Level
The anti-tip bracket attaches to the oor at the back of
the range to prevent range from tipping. When fastening
bracket to the oor, be sure that screws do not penetrate
electrical wiring or plumbing. The screws provided will
work in either wood or concrete.
(
C
L = Center line)
Figure 22
Range
Anti-Tip Bracket
Floor Mount
Screws
Floor
Rear of Range
Wall