Installation Guide

ManualsBrandsElectrolux ManualsAppliancesWave-Touch 4.6 cu. ft. Slide-In Dual Fuel Range with Self-Cleaning Convection Oven in Stainless Steel

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

(Models with an Electric Oven and a Gas Cooktop)

To avoid breakage: Do NOT handle or manipulate the

unit by the cooktop.

The counter-top around the cut-out should be at and leveled

(see hatched area on illustration 1).

Before installing the unit, measure the heights of the two (2) cabinet

sides (H1-4), front and back (Illustration 1) from the oor to the top of

the counter.

Illustration 1

Shave

Raised

Edge

to Clear

Space for

a 31½"

(80 cm) Wide

Cooktop.

1 ½" Max.

(3,8 cm Max.)

Remove the protective channels on each side of the cooktop (if

provided).

Slide the unit into the cabinet. Make sure the center of the unit is aligned with

the center of the cabinet cut-out.

Illustration 2

To successfully

install the

range, the

initial level

height from

oor to

underside of

cooktop frame

should be at

least 1/16"

taller than

cabinet sides

as measured in

step 2.

Level the range using the

two (2) front leveling legs

and the two (2) adjustable

leveling wheel, so that

the height from the oor

to the underside of the

metal ange is greater

than the tallest cabinet

After the installation, MAKE SURE that the

unit is supported by the two front leveling legs

and the two adjustable leveling wheels and

NOT by the cooktop.

Metal

Flange

The metal ange under each side of the cooktop MUST be placed

over the cabinet countertop for proper unit support. The cooktop

should NOT rest directly on the countertop (see illustration 2) or

else it could cause damage to the cooktop voiding the warranty.

Level the unit if needed.

measurement by at least 1/16" (see Ill. 2).

Remove and discard the two rear leveling legs, they are only

in place to solidify the unit for the transport.