Complete Owner's Guide

15
SurfaceBurner
Grate
SurfaceBurner
Caps
SurfaceBurner
Head
CautioN
- Use caution when replacing the burner head so the electrode is not damaged. A damaged electrode
may cause a delayed ignition or prevent the burner from igniting
- Any additions, changes or conversions required in order for this appliance to perform satisfactorily
must be made by a qualied service technician.
GeneralCare&Cleaning
CLEANING THE BURNER GRATES, BURNER CAPS AND
BURNER HEADS
TheGrates,BurnerCapsandtheLarge18kBurnerHeadshould
beroutinelycleaned.Keepingtheburnerportscleanwillprevent
improperignitionandanunevename.Ifneeded,thexedburners
should be cleaned in place with an humid cloth (do not spray water
on them).
Refer to the following instructions:
To Remove and Replace the Surface Burner Grate, Surface
BurnerCapandSurfaceBurnerHead- Remove in the following
order;(1st)SurfaceBurnerGrate,(2nd)SurfaceBurnerCap,(3rd)
Surface Burner Head (See Figure 1).
Reverse the procedure above to replace the Surface Burner Cap,
SurfaceBurnerHeadandSurfaceBurnerGrate.Donotremove
anyburnerpartsfromthecooktopuntiltheburnerpartshave
completelycooledandaresafetohandle.Donotoperatethe
surface burners without the Surface Burner Heads, Surface
BurnerCapsandSurfaceBurnerGratesproperlyinplace.
ToCleantheBurnerCaps,BurnerHeadsandBurnerGrates-
Useasoap-lledscouringpadoramildabrasivecleanertoclean
thesurfaceburnercapsandsurfaceburnerheads.TheGratesare
designed to be Dishwasher safe for cleaning. The ports (or slots)
around the burner heads must be routinely cleaned. If residue still
remains in these ports, use a small-gauge wire or needle to clean the slots or holes being
carefulnottodamagetheelectrode.Forproperowofgasandignitionoftheburner—DO
NOTALLOWSPILLS,FOOD,CLEANINGAGENTSORANYOTHERMATERIALTOENTER
THEGASORIFICEHOLDEROPENING.ALWAYS make sure that the surface burner cap,
the surface burner head and the surface burner grate are properly in place whenever a surface
burner is in use.
THE COOKTOP IS NOT REMOVABLE. Do not attempt to remove or lift the cooktop.
1st
2nd
3rd
Orice
Electrode
Surface
Burner
Head
Surface
Burner
Cap
Figure 1
SurfaceBurnerGrate