Use and Care Manual
43
Care & Cleaning
Removing and replacing the
oven door
To prevent possible burns, do not attempt to remove the
oven door until the oven has completely cooled.
To Remove Oven Door:
2. Pull the door hinge locks on both left and right door hinges
down from the oven frame completely towards the oven door
required.
3. Firmly grasp both sides of oven door along the door sides
4. Close the door to about a 10 degrees. The oven door will stop
into this position just before fully closing.
5. With the oven door in this position (Fig. 3), lift and carefully
damage, be careful not to allow the oven door hinges to
contact the oven front frame.
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door sides
2. Holding the oven door at the same angle as the removal
position, carefully line up and insert both door hinge arms
between the pins located on each side of the oven door
frame (Fig. 4)
3. With both door hinge arms in place, open the oven door
4. Push the door hinge locks up towards and into the oven
frame for both left and right oven door hinges (Fig. 2) to the
locked position.
5. Close the oven door.
Special Door Care Instructions
CAUTION-
Read the following recommendations:
•
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
time.
Figure 1 - Door hinge location
Figure 2 - Door hinge locks
Figure 3 - Holding door for removal
Figure 4 - Location of hinge arm
and roller pin
Oven door
hinge
location
About
Oven
door
Hinge
Roller
pin
Hinge
arm
The door is heavy. Be careful when removing and lifting
the door. Do not lift the oven door by the handle.