Installation guide

11
36" GAS RANGE INSTALLATION INSTRUCTIONS
7
Level the Range
Level the range and set cooktop height before
installation in the cut-out opening (if applicable).
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (Figure 13). Take two
readings with the level placed diagonally in one
direction and then the other.
3. Level the range, if necessary, by adjusting the four
leg levelers with a wrench (Figure 14).
4. Slide range into cut-out opening and double check
for levelness. If the range is not level, pull unit out
and readjust leveling legs, or make sure oor is level.
6
Install the Oven Racks
The oven racks are supported inside the oven cavity by
two ladder racks, installed on the oven walls.
1. Place the ladder racks hook-side up into the support
brackets located on the oven sides (see Figure 12).
2. Place the at oven racks into the desired positions.
To aid installation and movement of oven racks, apply
a thin layer of cooking oil to the sides of the oven racks
that contact the ladder supports.
Figure 13: Use the oven racks to level appliance
Figure 14: Adjusting appliance height
Figure 12: Ladder rack supports
Raise
Lower
Leg
Leveler