User manual

10
4. Select the desired option(s)
Depress the required button(s).
5. Select the temperature
Turn the dial to the required setting.
6. Select the programme and start the
machine
Turn the programme selector dial clockwise to the
required programme and press the ON/OFF button:
the mains on light comes on and the machine starts
to operate.
7. At the end of the programme
The machine stops automatically.
If you have depressed the ANTI-CREASE
button, the machine will stop with the water left in the
tub, to prevent the fabric from creasing. To drain the
water and spin, release the same button. To drain
only, select programme “12”.
The door is controlled by a safety device which
releases 2 minutes after the end of the programme.
Switch the machine off by depressing the ON/OFF
button again. The mains-on light goes out.
When the programme has finished you are advised
to unplug the appliance and turn off the water tap.
P0080
2
M0043S
M0042
60
Operating sequence
Before washing your first load of laundry, we
recommend that you run a cotton cycle at 60°C, with
the machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment .
If you wish to carry out a programme with prewash,
pour detergent into the appropriate compartment
marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
C0065
C0064
P0004
132995790.qxd 3/15/02 9:03 AM Pagina 10 (Nero/Process Black pellicola)