User manual

14
1 Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a
time, shaking them out as much as possible.
Close the door.
2 Measure out the detergent
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent
recommended by the manufacturer in a
graduated cup and pour it into the main wash
compartment . If you wish to carry out a
prewash, pour detergent into the appropriate
compartment marked .
3 Measure out the additives
If required, pour fabric softener into the
compartment marked without exceeding the
«MAX» mark.
4 Select the desired option(s)
5 Select the temperature
Turn the selector dial to the required
temperature setting.
6 Select the programme and start it
Turn the programme selector dial clockwise to
the required wash programme and press the
on/off button : the operating pilot light comes
on and the machine starts to operate.
7 At the end of the programme
The machine stops automatically, the operating
pilot light goes out.
If you have selected a gentle programme with
the anticrease option
,
drain the water before
opening the door.
It is normal to have to wait for about 2 minutes
before being able to open the door to allow the
safety lock to release.
Press the on/off button again.
Operating sequence
Remove the laundry.
Turn the drum by hand to make sure it is completely
empty, so as to avoid any forgotten items being
damaged in a subsequent wash (e.g. shrinking) or
their colour running into a load of whites.
Release any buttons which have been pressed.
Turn the water tap off and unplug the machine.
Leave the door ajar to air the machine.
P1018
P1019
2
M0043S
P0033
M0042
60