User manual
Table Of Contents
- CONTENTS
- 1. SAFETY INFORMATION
- 2. SAFETY INSTRUCTIONS
- 3. INSTALLATION
- 4. ACCESSORIES
- 5. PRODUCT DESCRIPTION
- 6. CONTROL PANEL
- 7. DIAL AND BUTTONS
- 8. PROGRAMMES
- 9. SETTINGS
- 10. BEFORE FIRST USE
- 11. DAILY USE
- 11.1 Activating the appliance
- 11.2 Loading the laundry
- 11.3 Using detergent and additives
- 11.4 Changing position of detergent divider
- 11.5 Setting a programme
- 11.6 Starting a programme
- 11.7 Starting a programme with the delay start
- 11.8 The SensiCare System load detection
- 11.9 Interrupting a programme and changing the options
- 11.10 Cancelling a running programme
- 11.11 Opening the door - Adding garments
- 11.12 End of the programme
- 11.13 Draining water out after end of cycle
- 11.14 Stand-by option
- 12. HINTS AND TIPS
- 13. CARE AND CLEANING
- 13.1 Periodic cleaning schedule
- 13.2 External cleaning
- 13.3 Descaling
- 13.4 Maintenance wash
- 13.5 Door seal with double lip trap
- 13.6 Cleaning the drum
- 13.7 Cleaning the detergent dispenser
- 13.8 Cleaning the drain pump
- 13.9 Cleaning the inlet hose and the valve filter
- 13.10 Emergency drain
- 13.11 Frost precautions
- 14. TROUBLESHOOTING
- 15. CONSUMPTION VALUES
- 16. TECHNICAL DATA
- 17. QUICK GUIDE
Problem Possible solution
The appliance makes
an unusual noise and
vibrates.
• Make sure the levelling of the appliance is correct. Refer
to "Installation instruction".
• Make sure that the packaging and/or the transit bolts
are removed. Refer to "Installation instruction".
• Add more laundry in the drum. The load may be too
small.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
• The SensiCare System is able to adjust the programme
duration according to the type and the laundry load size.
Refer to "The SensiCare System load detection" in "Dai‐
ly Use" chapter.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains be‐
fore you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Too much foam in the
drum during the wash‐
ing cycle.
• Reduce the quantity of detergent.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
• Make sure that the detergent insert is in the correct po‐
sition.
• Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
15. CONSUMPTION VALUES
Stated values are obtained in laboratory conditions with relevant stand‐
ards. Different causes can change the data: the quantity and type of
laundry and ambient temperature. Water pressure, the supply voltage
and the temperature of inlet water may also affect the washing pro‐
gramme duration.
Technical specifications may be changed without prior notice to improve
the quality of product.
ENGLISH 33