User manual

3.
B
4.
• Position A for powder detergent (factory setting).
• Position B for liquid detergent.
When you use the liquid detergent:
• Do not use gelatinous or thick liquid detergents.
• Do not put more liquid then the maximum level.
• Do not set the delay start (or Finish in option).
10.5 Activating the appliance
Press and hold for a couple of seconds
the
button to activate or deactivate
the appliance.
A tune sounds when the appliance is
activated. The appliance performs a start
up animation. The animation quickly
shows each washing programme and the
default temperature and spin settings.
The display shows the word On.
10.6 Setting a programme
1. Touch the programme button and
set the programme:
• The indicator of the button
flashes.
• The display shows the
programme duration.
2. If necessary, change the temperature
and the spin speed or add available
options. When you activate an
option, the indicator of the set option
comes on.
If you set something
incorrect, the display shows
the message .
10.7 Starting a programme
without the Finish In option
Touch the button .
• The indicator of the button
stops to flash and stays on.
• The programme starts, the door
locks, the indicator is on.
• The drain pump can operate for a
short time at the beginning of the
washing cycle.
After approximately 15
minutes from the start of the
programme:
• The appliance adjusts
automatically the
programme duration
agree with the laundry
load.
• The display shows the
new value.
10.8 Starting a programme with
the Finish In option
1. Touch the button again and again
to choose the number of hours in
ENGLISH 13