User manual

You must select this option after you have
set the programme and before you press
button Start Pause.
You can cancel or modify the delay time at
any moment, before you press button Start
Pause.
Cancelling the delayed start after having
pressed button Start Pause :
1. Set the washing machine to PAUSE by
pressing button Start Pause.
2. Press the button 6 repeatedly until the
light relevant to the selected delay goes
off.
3. Press button Start Pause again to
start the programme.
Important! The selected delay can be
changed only after selecting the washing
programme again.
The door will be locked throughout the de-
lay time (door locked light lit).
The Delay Start can not be selected with
DRAIN or SPIN programme.
START THE PROGRAMME BY
PRESSING BUTTON 5
To start the selected programme, press this
button; the corresponding pilot light stops
flashing and remains lit.
On programme progress display the pilot
lights "Washing" and "Door" illuminate to in-
dicate that the appliance starts operating
and the door is locked.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change any option before
the programme carries it out.
Before you make any change, you must
pause the washing machine by pressing the
button Start/Pause.
The programme can be changed as long as
the button Start/Pause has not been
pressed. Changing a running programme is
possible only by resetting it. Turn the pro-
gramme selector dial to "Aus/Arrêt" and
then to the new programme position. Start
the new programme by pressing the button
Start/Pause again.
INTERRUPTING A PROGRAMME
Press the button Start\Pause to interrupt a
programme which is running, the corre-
sponding light starts to flash. Press the but-
ton again to restart the programme.
CANCELLING A PROGRAMME
Turn the selector dial to "Aus/Arrêt" posi-
tion to cancel a programme which is run-
ning. Now you can select a new pro-
gramme.
OPENING THE DOOR AFTER THE
PROGRAMME HAS STARTED
First set the machine to pause by pressing
the button Start\Pause.
After some minutes, the door can be
opened, when the following conditions are
observed:
• The water temperature is below 55°C.
• The water level is below the bottom edge
of the door.
• The machine doesn’t spin.
If you cannot open the door but it is abso-
lutely necessary to open it you have to
switch the machine off by turning the selec-
tor dial to "Aus/Arrêt". After few minutes
the door can be opened
(Pay attention to the water level and
temperature!).
After this procedure, it will be necessary to
set the programme and the options again
and then press the button Start\Pause.
AT THE END OF THE PROGRAMME
The machine stops automatically.
The pilot light " End" illuminates to indicate
that the programme has finished. The pilot
light "Door" goes out, the door can be
opened and the laundry can be removed.
If at the end of a programme there is water
in the tub (when the Rinse Hold option has
been selected), to empty out the water
follow the following instructions:
• turn the programme selector dial to
"Aus/Arrêt"
• select the «Drain» or «Spin» programme
•press the "Start" button
When the pilot light "Door" goes out, the
door can be opened and the laundry can
be removed.
At the end of the cycle, turn the programme
selector dial to "Aus/Arrêt" to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
10 electrolux