User manual

SELECT THE REQUIRED PROGRAMME
BY MEANS OF THE PROGRAMME
SELECTOR DIAL (9)
Turn the programme selector dial to the re-
quired programme. The selector can be
turned either clockwise or anticlockwise.
The green light of button 6 starts to flash
On programme progress display the pilot
lights corresponding to all phases compos-
ing the selected programme are lit.
On position "Aus/Arrêt" the programme is
reset and the machine is switched OFF.
At the end of the programme the selec-
tor dial must be turned to position
"Aus/Arrêt" to switch the machine off.
Important! If you turn the programme
selector dial to another programme when
the machine is working, the lights in the
programme progress display will start to
flash to indicate a wrong selection. The
machine will not perform the new selected
programme.
SELECT THE SPIN SPEED, RINSE
HOLD OR NO SPIN OPTION (8)
Select the spin speed, Rinse Hold option or
No Spin option by turning the spin speed
selector.
• The position 1000 is equivalent to 900
rpm for the synthetic and wool/handwash
programmes and 700 rpm for the deli-
cate wash and mini programme.
Rinse hold
By selecting this option the water of the last
rinse is not emptied out to prevent the fab-
rics from creasing. When the programme
has finished, the lights "End" and "Door"
are lit to indicate that the water must be
emptied out (See: " At the end of the pro-
gramme").
No spin
By selecting this option all the spinning
phases are excluded. To be used for ex-
tremely delicate material. The machine will
add some additional rinses to the cotton
and synthetic programmes.
For the maximum spin speed allowed by
each programme, refer to the chapter
Washing programmes.
SELECT THE DESIRED OPTION BY
MEANS OF BUTTONS 2, 3 AND 4
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired pro-
gramme and before pressing the button
Start Pause.The relevant light will illumi-
nate.
h 8
Start
Pause
Zeit-
vorwahl
Marche
Pause
Extra
Spülen
Rinçage
Plus
Vor-
wäsche
Extra Court
Court
Pré-
lavage
Départ
Diéré
Kurz
Extra Kurz
If an incorrect option is selected, the corre-
sponding indicator lamp flashes for about 2
seconds. For the compatibility of the op-
tions with the washing programmes, refer
to the chapter «Washing programmes».
SELECT THE DELAY START BY
PRESSING BUTTON 6
Before you start the programme, if you wish
to delay the start, press the button 6 re-
peatedly, to select the desired delay. The
corresponding pilot light will light up.
Tür
Porte
Ende
Fin
Waschen
2h
4h
h 8
Lavage
Zeit-
vorwahl
Départ
Diéré
electrolux 9