user manual Washing Machine EWF 12270W
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com Contents Safety information Product description Control panel First use Daily use Helpful hints and tips Washing programmes 2 4 5 7 7 10 12 Care and cleaning What to do if… Technical data Consumption values Installation Electrical connection Environment concerns 14 18 20 20 21 24 24 Subject to change without notice Safety information Important! Read carefully & keep for future reference.
electrolux 3 Installation • This appliance is heavy. Care should be taken when moving it. • When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre. • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual.
electrolux Product description Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. 1 2 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available).
electrolux 5 Programme Chart Various programme charts in different languages are supplied with the appliance. One is on the front side of the detergent dispenser drawer and the others are attached into the user manual assy. The chart in the drawer can be replaced easily: remove the chart from the drawer by pulling it towards the right and insert the chart with the language required.
electrolux Night Cycle By selecting this function the machine will not drain the water of the last rinse and all spinning phases will be suppressed, so as not to wrinkle the laundry. This washing cycle is very quiet and it can be selected at night or in times with a more economical power rate. On some programmes the rinses will be performed with more water. Before opening the door it will be necessary to empty out the water. To empty out the water, please read the paragraph «At the end of the programme».
electrolux 7 Display 5.2 The display shows the following information: 5.1: • Duration of selected programme After selecting a programme, the duration is displayed in hours and minutes (for example ). The duration is calculated automatically on the basis of the maximum recommended load for each type of fabric. After the programme has started, the time remaining is updated every minute.
electrolux drum, one item at a time, shaking them out as much as possible. Close the door. Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment or in the appropriate compartment if the selected programme/option it requires (see more details in «Detergent dispenser drawer»).
electrolux 9 ses the maximum spin speed provided for that programme. Press button 2 repeatedly to change the spin speed, if you want your laundry to be spun at a speed different from the one proposed by the washing machine. The relevant light will light up. Select the available options by pressing buttons 2, 3 and 4 Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before starting the programme.
electrolux Opening the door After the programme has started (or during the delay time) the door is locked, if you need to open it, set first the machine to PAUSE by pressing the button 6 . After a few minutes the light 8.2 goes out and it is possible to open the door. If this light remains lit and the door is locked, this means that the machine is already heating or that the water level is too high.
electrolux 11 • Synthetics: drum no more than half full; • Delicate fabrics and woollens: drum no more than one third full. Washing a maximum load makes the most efficient use of water and energy. For heavily soiled laundry, reduce the load size.
electrolux of the water in your area can be obtained from the relevant water supply company, or from your local authority. Level A water softener must be added when water has a medium-high degree of hardness (from degree of hardness II). Follow the manufacturer’s instructions. The quantity of detergent can then always be adjusted to degree of hardness I (= soft). Characteristic Degrees of water hardness German °dH French °T.H.
electrolux 13 Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options COTTON WITH PREWASH 60° Prewash - Main wash - Rinses Maximum spin speed 1200 rpm Max. load 6 kg - Red. load 3 kg 1) For white or coloured cottons with prewash phase (heavily soiled items). SPIN, RINSE HOLD, NIGHT CYCLE, DAILY, LIGHT, QUICK, EXTRA RINSE SYNTHETIC 60°-30° Main wash - Rinses Maximum spin speed 900 rpm Max. load 3 kg - Red.
electrolux Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment DRAIN Draining of water Max. load 6 kg For emptying out the water of the last rinse in programmes with the Rinse Hold and Night Cycle option selected. SPIN Drain and long spin Maximum spin speed 1200 rpm Max. load 6 kg Separate spin for hand washed garments and after programmes with the Rinse Hold and Night Cycle option selected.
electrolux 15 2. Remove the conditioner insert from the appropriate compartment. 6. Insert the detergent dispenser drawer in the guide rails and push it in. Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. Important! Do not clean the drum with acidic descaling agents, scouring agents containing chlorine or iron or steel wool. 1. Remove any rust deposits on the drum with a cleaning agent for stainless steel. 2.
electrolux Drain pump The pump should be inspected regularly and particularly if: • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1. Disconnect the appliance. 2. If necessary wait until the water has cooled down. 3. Open the pump door. 7. Remove any objects from the pump impeller by rotating it. 8.
electrolux 17 Cleaning the water inlet filters If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. 1. Turn off the water tap. 2. Unscrew the water inlet hose. 3. Clean the filter in the hose using a hard bristle brush. 4. Screw the hose back onto the tap. 5. Unscrew the hose from the machine. Keep a rug nearby because some water may flow. 6. Clean the filter in the valve with a stiff brush or with the piece of cloth. 7.
electrolux What to do if… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 6 blinks, one of the following alarm codes appears on the display to indicate that the machine is not working: • : problem with the water supply. • : problem with the water draining.
electrolux 19 Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain hose is damaged. • Change it with a new one.
Mo Prodd. ... . No ... ... . ... ... .. Se r. No . ... ... ... 20 electrolux Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ... Technical data Dimensions Width Height Depth 60 cm 85 cm 63 cm Electrical connection Voltage - Overall power - Fuse Information on the electrical connection is given on the rating plate, on the inner edge of the appliance door.
electrolux 21 Installation Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom. 4. Slide out the relevant plastic spacers. 2.
electrolux Caution! Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. 6. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. Water inlet Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance.
electrolux 23 machine. In this case, make sure the end cannot come unhooked when the machine is emptying. This could be done by tying it to the tap with a piece of string or attaching it to the wall. 3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. The inlet hose must not be lengthened.
electrolux Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. injury through failure to comply with the above safety precaution. The power supply cable must be easily accessible after installing the machine.
electrolux 25
electrolux
electrolux 27
www.electrolux.com www.