user manual Washing Machine Downloaded From WashingMachine-Manual.
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com Contents 2 4 5 7 7 9 11 Care and cleaning 13 What to do if… 16 Technical data 19 Consumption values 19 Installation 20 Electrical connection 23 Environment concerns 23 Subject to change without notice Important! Read carefully & keep for future reference. • The safety of Your appliance complies with the industry standards and with legal requirements on the safety of appliances.
electrolux 3 • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance.
electrolux Product description Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy.
electrolux 5 Programme Chart Various programme charts in different languages are supplied with the appliance. One is on the front side of the detergent dispenser drawer and the others are attached into the user manual assy. The chart in the drawer can be replaced easily: remove the chart from the drawer by pulling it towards the right and insert the chart with the language required. Control panel Below is a picture of the control panel.
electrolux Extra Rinse This appliance is designed to save energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses will be performed. This option is recommended for people who are allergic to detergents, and in areas where the water is very soft. Delay Start The start of the programme can be delayed by 2, 4 or 8 hours by means of this button. Start Pause This button allows you to start or to interrupt the selected programme.
electrolux 7 First use • Ensure that the electrical and water connections comply with the installation instructions. • Remove the polystyrene block and any material from the drum. • Pour 2 liters of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at the highest temperature without any laundry in the machine, to remove any manufacturing residue from the drum and tub.
electrolux will automatically select the maximum spin value provided for the programme you have chosen. You can change this value by pressing the corresponding button. The green pilot light of the button 5 starts to flash. The selector dial can be turned either clockwise or counterclockwise. Turn to position « O » to reset programme/Switching the machine off. At the end of the programme the selector dial must be turned to position O, to switch the machine off.
electrolux 9 Altering an option or a running programme It is possible to change some options before the programme carries them out. Before you make any change, you must PAUSE the appliance by pressing the button 5. Changing a running programme is possible only by resetting it. Turn the programme selector dial to O and then to the new programme position. Start the new programme by pressing the button 5 again. The washing water in the tub will be not emptied out.
electrolux Button up pillowcases, close zip fasteners, hooks and poppers. Tie any belts or long tapes. Remove persistent stains before washing. Rub particularly soiled areas with a special detergent or detergent paste. Treat curtains with special care. Remove hooks or tie them up in a bag or net. Removing stains Stubborn stains may not be removed by just water and detergent. It is therefore advisable to treat them prior to washing. Blood: treat fresh stains with cold water.
electrolux 11 degree of hardness is soft, readjust the quantity of the detergent. Washing programmes Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options Detergent Compartment SPIN NIGHT CYCLE RINSE HOLD PREWASH DAILY SUPER QUICK1) EXTRA RINSE 2) COTTONS ECONOMY 60° Main wash - Rinses Long spin at maximum spin speed (800/1000/1200 rpm depending on a model) Max.
electrolux Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options SPIN NIGHT CYCLE RINSE HOLD PREWASH DAILY SUPER QUICK 1) EXTRA RINSE 2) SPIN (only for model EWF 86110W) NIGHT CYCLE RINSE HOLD PREWASH DAILY SUPER QUICK 1) EXTRA RINSE 2) SYNTHETICS 60°- COLD Main wash - Rinses Maximum spin speed 900 rpm or 800 rpm - depending on a model Max. load 3 kg - Red.
electrolux 13 Programme Maximum and Minimum Temperature Cycle Description Maximum Spin Speed Maximum Fabrics Load Type of Laundry Options SPIN Drain and long spin Long spin at maximum spin speed (800/1000/1200 rpm depending on a model) Max. load 6 kg Separate spin for hand washed garments and after programmes with the Rinse Hold and Night Cycle option selected. You can choose the spin speed by pressing the relevant button to adapt it to the fabrics to be spun.
electrolux Cleaning the dispenser drawer The detergent dispenser drawer should be cleaned regularly. 1. Remove the detergent dispenser drawer by pulling it firmly. Remove any traces of accumulated powder. To aid cleaning, the top part of the additive compartment should be removed. 6. Insert the detergent dispenser drawer in the guide rails and push it in. Washing drum Rust deposits in the drum may occur due to rusting foreign bodies in the washing or tap water containing iron. 2.
electrolux 15 Drain pump The pump should be inspected regularly and particularly if: • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: 1. Disconnect the appliance. 2. If necessary wait until the water has cooled down. 3. Open the pump door. keep a rag nearby to dry up spillage of water when removing the pump. 7. Remove any objects from the pump impeller by rotating it. 8.
electrolux Cleaning the water inlet filters If you notice that the machine is taking longer to fill, check that the filter in the water inlet hose is not blocked. 1. Turn off the water tap. 2. Unscrew the water inlet hose. 3. Clean the filter in the hose using a hard bristle brush. 4. Screw the hose back onto the tap. 5. Unscrew the hose from the machine. Keep a rug nearby because some water may flow. 6. Clean the filter in the valve with a stiff brush or with the piece of cloth. 7.
electrolux 17 solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 5 blinks to indicate that the machine is not working. Once the problem has been eliminated, press the button 5 to restart the programme. If after all checks, the problem persists, contact your local Service Centre.
electrolux Problem Possible cause/Solution Unsatisfactory washing results: Too little detergent or unsuitable detergent has been used. • Increase the detergent quantity or use another one. Stubborn stains have not been treated prior to washing. • Use commercial products to treat the stubborn stains. The correct temperature was not selected. • Check if you have selected the correct temperature. Excessive laundry load. • Reduce the laundry load. The door will not open: The programme is still running.
electrolux 19 Mo Prodd. ... . No ... ... . ... ... .. Se r. No . ... ... ... If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine: the Service Centre will require this information. Mod. ... ... ... Prod. No. ... ... ... Ser. No. ... ... ...
electrolux Installation Unpacking All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. After removing all the packaging, carefully lay machine on it’s back to remove the polystyrene base from the bottom. 4. Slide out the relevant plastic spacers. 2.
electrolux 21 Water inlet Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet.
electrolux tap, you will have to purchase a new, longer hose specially designed for this type of use. Important! Before connecting up the machine to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Water drainage The end of the drain hose can be positioned in three ways. • Hooked over the edge of a sink using the plastic hose guide supplied with the machine.
electrolux 23 Electrical connection Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket. injury through failure to comply with the above safety precaution. The power supply cable must be easily accessible after installing the machine.
www.electrolux.com Downloaded From WashingMachine-Manual.
