User manual

Altering an option or a running
programme
It is possible to change some options
before the programme carries it out.
Before you make any change, you
must pause the washing machine by
pressing the button
5. Changing a
running programme is possible only by
resetting it. Turn the programme
selector dial to
O
and then to the new
programme position. Start the new
programme by pressing the button 5
again. The washing water in the tub will
be not emptied out.
Interrupting a programme
Press the button
5 to interrupt a
programme which is running, the green
pilot light starts blinking. Press the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to
O
to cancel a
programme which is running. Now you
can select a new programme.
Opening the door after the
programme has started
First set the machine to pause by
pressing the button
5. if the pilot light
7.2 blinks and after some minutes
goes off, the door can be opened.
If the pilot light
7.2 is still on and the
door remains locked this means that
the machine is already heating, that the
water level is above the bottom edge
of the door.
If you cannot open the door but you
need to open it you have to switch the
machine off by turning the selector dial
to
O
.
After a few minutes the door can be
opened (pay attention to the water
level and temperature!).
After closing the door, it is necessary to
select the programme and options
again and to press button
5.
At the end of the programme
The machine stops automatically, the
pilot light of button
5, the pilot lights
7.1 and 7.2 go off and the pilot light
7.3 goes on.
If a programme or an option that ends
with water still in the tub has been
selected, the pilot light
7.2 remains lit,
the pilot light of button 5 goes off and
the door remains locked to indicate
that the water must be emptied out
before opening the door.
Follow the below instructions to empty
out the water:
Turn the programme selector dial to
O
● select the DRAINING or SPINNING
programme
● reduce the spin speed if needed, by
pressing the relevant button
● press button 5
When the programme has finished the
pilot light 7.2 goes off and the door
can be opened. Turn the programme
selector dial to
O
t
o switch the
machine off. Remove the laundry from
the drum and carefully check that the
drum is empty. If you do not intend to
carry out another wash, close the
water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
use electrolux 13
132962580_EN.qxd 08/07/2008 14.05 Pagina 13