User manual

32 electrolux installation
Connect the water inlet hose to a tap with
3/4” BSP thread.
This could be done by tying it to the tap
with a piece of string or attaching it to the
wall.
In a sink drain pipe branch. This
branch must be above the trap so that the
bend is at least 60 cm above the ground.
Directly into a drain pipe at a height
of not less than 60 cm and not more than
90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the
drain pipe must be larger than the outside
diameter of the drain hose.
The drain hose must not be kinked. Run it
along the floor; only the part near the
drainage point must be raised.
For the correct functioning of the
machine the drain hose must remain
hooked on the proper support piece
situated on the top part of back side
of the appliance.
Use the hose supplied with the washing
machine. DO NOT USE OLD HOSES.
The other end of the inlet hose which
connects to the machine can be turned in
any direction.
Simply loosen the fitting, rotate the hose
and retighten the fitting, making sure there
are no water leaks.
The inlet hose must not be lengthened. If it
is too short and you do not wish to move
the tap, you will have to purchase a new,
longer hose specially designed for this
type of use.
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
Water inlet
Water drainage
90 cm 60 cm
In this case, make sure
the end cannot come
unhooked when the
machine is emptying.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor.