user manual Washing Machine EWF 108210 W
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 • All packing and transit bolts must be removed before use. Serious damage can occur to the product and to property if this is not adhered to. See relevant section in the user manual. • After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable against the wall. • If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely under the appliance.
electrolux PRODUCT DESCRIPTION Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. Its new washing system allows total use of detergent and reduces water consumption so saving energy. 1 2 3 4 5 6 1 Detergent dispenser drawer 2 Control panel 3 Door opening handle Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available).
electrolux 5 CONTROL PANEL Below is a picture of the control panel. It shows the programme selector dial as well as the temperature selector dial, the buttons and the pilot lights. These are presented by relevant numbers on the following pages.
electrolux Rinse hold By selecting this function the water of the last rinse is not emptied out to prevent the fabrics from creasing. Before opening the door it will be necessary to empty out the water. To empty out the water, please read the paragraph «At the end of the programme». Night Cycle By selecting this function the machine will not drain the water of the last rinse and all spinning phases will be suppressed, so as not to wrinkle the laundry.
electrolux 7 DAILY USE Load the laundry Open the door by carefully pulling the door handle outwards. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Close the door. Measure out the detergent and the fabric softener Pull out the dispenser drawer until it stops.
electrolux Spin position Programmes with max 1000 rpm allowed Programmes with max 900 rpm allowed Programmes with max 700 rpm allowed «1000» 1000 900 700 «900» 900 900 700 «700» 700 700 700 «500» 500 500 500 If you select the spin programme and the spin speed dial remains on this position, the spin will be performed by the appliance at 400 rpm . If you select the spin programme and the spin speed dial remains on this position, the spin will be performed by the appliance at 400 rpm .
electrolux 9 Interrupting a programme Press the button 6 to interrupt a programme which is running, the corresponding green pilot light starts blinking. Press the button again to restart the programme. Cancelling a programme to cancel a proTurn the selector dial to gramme which is running. You can select now a new programme. Opening the door After the programme has started (or during the delay time) the door is locked, if you need to open it, set first the machine to PAUSE by pressing the button 6 .
electrolux Blood: treat fresh stains with cold water. For dried stains, soak overnight in water with a special detergent then rub in the soap and water. Oil based paint: moisten with benzine stain remover, lay the garment on a soft cloth and dab the stain; treat several times. Dried grease stains: moisten with turpentine, lay the garment on a soft surface and dab the stain with the fingertips and a cotton cloth. Rust: oxalic acid dissolved in hot water or a rust removing product used cold.
electrolux 11 WASHING PROGRAMMES Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Algodón 90° - Cold Main wash - Rinses Maximum spin speed at 1000 rpm Max. load 8 kg - Red. load 4 kg 1) White and coloured cotton (normally soiled items). SPIN REDUCTION NIGHT CYCLE RINSE HOLD PREWASH2) DAILY SUPER QUICK EXTRA RINSE Sintéticos 60° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max. load 4 kg - Red.
electrolux Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Remojo 30° Prewash - Soak for about 40 minutes - Stop with water in the tub Max. load 8 kg Special programme for heavily soiled laundry. The machine performs a soak at 30°C. At the end of this time the machine will stop automatically with water left in the tub.
electrolux 13 Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Algodón económico 3) 90° - 40° Main wash - Rinses - long spin Maximum spin speed at 1000 rpm Max. load 8 kg his programme can be selected for slightly or normally soiled cotton items. The temperature will decrease and the washing time will be extended. This allows to obtain a good washing efficiency by saving energy.
electrolux After each wash Leave the door open for a while. This helps to prevent mould and stagnant smells forming inside the appliance. Keeping the door open after a wash will also help to preserve the door seal. 2. Remove the conditioner insert from the appropriate compartment. Maintenance wash With the use of low temperature washes it is possible to get a build up of residues inside the drum. We recommend that a maintenance wash be performed on a regular basis.
electrolux 15 2. Run a washing cycle without any washing to clean off any cleaning agent residues. Programme: Short Cotton Programme at maximum temperature and add approx. 1/4 measuring cup of detergent. 4. Place a container close to the pump to collect any spillage. 5. Release the emergency emptying hose, place it in the container and remove its cap cover. Door seal Check from time to time the door seal and eliminate eventual possible objects that could be trapped in the fold.
electrolux Warning! When the appliance is in use and depending on the programme selected there can be hot water in the pump. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the cover, ensure it is securely retightened so as to stop leaks and young children being able to remove it.
electrolux 17 WHAT TO DO IF… Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red pilot light of button 6 blinks to indicate that the machine is not working. It is possible to recognize the machine fault by the number of button 6 light flashes.
electrolux Problem Possible cause/Solution The drain hose is squashed or kinked (the button 6 red light blinks). • Check the drain hose connection. The drain filter is clogged (the button 6 red light blinks). • Clean the drain filter. The machine does not empAn option or a programme that ends with the water still in the tub or ty and/or does not spin: a that eliminates all the spinning phases has been selected. • Select the draining or spinning programme.
electrolux 19 Problem Possible cause/Solution The machine makes an unusual noise: The machine is fitted with a type of motor which makes an unusual noise compared with other traditional motors. This new motor ensures a softer start and more even distribution of the laundry in the drum when spinning, as well as increased stability of the machine. No water is visible in the drum: Machines based on modern technology operate very economically using very little water without affecting performance.
electrolux Programme Wool/ Handwash 30° Energy consumption (KWh) Water consumption (litres) Programme duration (Minutes) 0.4 65 55 1) «Cottons Eco» at 60°C with a load of 8 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards. The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the quantity and type of laundry, on the inlet water temperature and on the ambient temperature.
electrolux 21 5. Open the porthole and remove the polystyrene block fitted on the door seal. Positioning Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable.
electrolux Water inlet Warning! This appliance must be connected to a cold water supply. 1. Connect the water inlet hose supplied with the machine to a tap with a 3/4" thread. Always use the hose supplied with the appliance. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
electrolux 23 The drain hose may be extended to a maximum of 4 metres. An additional drain hose and joining piece is available from your local Service Centre. ELECTRICAL CONNECTION Information on the electrical connection is given on the rating plate on the inner edge of the appliance door. Check that your domestic electrical installation can take the maximum load required, also taking into account any other appliances in use. Connect the machine to an earthed socket.
electrolux can then be washed at a lower temperature. • Measure out detergent according to the water hardness, the degree of soiling and the quantity of laundry being washed.
electrolux 25
electrolux
electrolux 27
www.electrolux.